The lights on the 2210 modem indicate the status of the modem and its connection state.
When the modem is first turned on it performs a Power On Self Test
or POST. Reference the table below for the appropriate lights after initial power up.

NOTE: The 13 state SBC region has it's version of this modem, it's gui has very limited options compared to the bellsouth version
13 state SBC region = 2210-002-1002
9 state bellsouth region = 2210-002-1006

---

LED	Power	Ethernet	DSL	Internet	Activity
	Modem is not powered on	No ethernet link or modem is not powered on	Modem is not powered on	Modem is set to bridge mode or modem is not powered on	No WAN traffic or modem is not powered on
	Modem is powered on	LAN device is connected	Modem is in sync	Modem PPPoE Client is connected	N/A
	N/A	LAN  traffic	Modem is attempting to sync	Modem PPPoE client is attempting to connect	WAN traffic
	N/A	N/A	Modem failed to sync 3 times	N/A	N/A
	POST	N/A	No DSL signal	N/A	N/A
	POST Failed	N/A	N/A	Modem PPPoE client failed to connect	N/A

---

---

got feedback? got feedback?

Any feedback you provide is sent to the owner of this FAQ for possible incorporation and shown publically as well.

by wayjac edited by FAQFixer
last modified: 2008-02-25 09:59:36