dslreports logo
site
spacer

spacer
 
    All FAQs Site FAQ DSL FAQ Cable Tech About DSL Distance DSL Hurdles »»
spc

spacer




how-to block ads



This Section
This modem is highly configurable by ISPs so this may not even work for some. If you don't know what you're doing - DON'T DO THIS. You may be charged for replacement if you muck it up.

AND DON'T SAY YOU HAVEN'T BEEN WARNED.

1). Your source IP *must* be in the 192.168.1.x subnet. Statically set a PC to something like 192.168.1.5 (not .1, that's the modem).

2). Telnet to 192.168.1.1 with a password of "mspgzyx".

My version is stuck in BRIDGE mode, regardless the setting.

Other ISP versions (and possibly other EL/Covad versions for that matter) may vary widely from this.

NOTE: To get your ADSL Line Stats run the commands that are in bold seen in the Telnet output shown below:

quote:
ChangeMe> wan adsl chandata
near-end interleaved channel bit rate: 0 kbps
near-end fast channel bit rate: 3008 kbps
far-end interleaved channel bit rate: 0 kbps
far-end fast channel bit rate: 384 kbps

ChangeMe> wan adsl linedata near
relative capacity occupation: 88%
noise margin downstream: 6.5 db
output power upstream: 12.0 dbm
attenuation downstream: 47.5 db

ChangeMe> wan adsl linedata far
relative capacity occupation: 59%
noise margin upstream: 16.0 db
output power downstream: 20.0 dbm
attenuation upstream: 31.5 db


Expand got feedback?

by Bill_MI See Profile edited by Doctor Olds See Profile
last modified: 2009-07-02 00:27:56