dslreports logo
site
spacer

spacer
 
    «« DSL Hurdles Share Tool
spc

spacer




how-to block ads




3. PPPoE Information

Windows XP Professional ADSL Setup

1. Go to Start > Control Panel

2. Double click on Network and Internet connection

3. Under the Pick a Task Page click on Setup or change your Internet Connection

4. On the Internet Properties screen, click on the setup button

5. On the Welcome to the New Connection Wizard click Next

6. Click on Connect to the Internet button and click Next

7. Click on Setup my connection manually and click Next

8. Click on Connect using a broadband connection that requires a user name and password and click Next

9. Type in SNET DSL click Next

10. Type in User name and password and reconfirm password and click Next

11. Place a check in the Add a shortcut to the desktop box and click Finish

Good pictorials

by MrFixitCT See Profile
last modified: 2004-02-19 17:45:11

**This config is specifically for users that will be connecting directly to the DSL service and not using a router.**

Type 'adsl-setup'

It will do some system checks.

The next question will be for your user name. Type UserID@snet.net Hit 'enter'.

Next it will ask for the interface i.e. your NIC that you are using. Most likely 'eth0'. Unix starts with zero when it comes to assigning device numbers. eth0 is default, so just hit enter.

Next it will ask about 'Demand or Continuously'. Default is 'No'. Hit Enter.

Now it will ask you for your DNS's one at a time.
Type '204.60.203.179' for #1. Hit Enter.
Type '66.73.20.40' for #2. Hit Enter.

Next will be your UserID password.
Type it, hit enter, type it again to confirm, hit enter.

Next will be for firewalling. Press the number zero. Remember when you installed Red Hat, it asked you for high, medium, or low firewall. The firewall in the installation will be good enough. I had some trouble getting numbers 1 and 2 to work correctly in this selection. Maybe just me being a Linux newbie, but zero worked for me.

'Start connection at boot time?' Enter 'yes'.

Now it will show a summary of what you did and will ask you if you want to 'Accept these settings?' Enter 'y' for yes, hit 'Enter'

Next, type 'adsl-start' at the command line.

Now you should be online. Congrats.

The above config is for standalone PCs connecting directly to their DSL service

by Harddrive See Profile edited by MrFixitCT See Profile
last modified: 2004-08-14 14:39:32

Yes!

If you follow the instructions here and use all of the examples it has, you can get it to work as well!

**note that with OpenBSD version >2.9, you need to put the nat rules at the top of your pf.conf.
Then, you can start pf at ppp linkup by adding this to your /etc/ppp/ppp.linkup (this is different then what the link says, since the version the page uses looks like 2.9)

! sh -c "/sbin/route del default"
! sh -c "/sbin/route add default HISADDR -mtu 1492"
! sh -c "/sbin/ifconfig pflog0 up"
! sh -c "/sbin/pfctl -e -l tun0 -F all -O aggressive -R /etc/pf.conf"

the first 2 add the default routes to your routing table, the 3rd starts pf logging, and the last starts your pf firewall rules.

after this, you can dial out using

route flush
ppp -ddial pppoe

You will be connected using the tun0 interface, not ppp0. Its ok, because it still works!

by phriday613 See Profile edited by Kevin See Profile
last modified: 2003-07-23 20:59:45