Equipment Support > Hardware By Brand > Westell > How to use my Linksys wireless router with my 327w

reply to ardenj

Re: How to use my Linksys wireless router with my 327w

How do I similar set-up with Netgear MR814v2? Has anyone anyone done this or any ideas would be appreciated. Especially step-by-step instructions like how BIRDS does would be a huge help.

Using method 3, is there anyway to access the Westell's configuration webpage? With my old Covad setup, I had the ZyXel modem in Bridged mode and I used the console port on the modem to access the configuration. But the Westell only has a web configuration page, so I don't know how to connect to it? Can I setup a static route to access it on the Westell or my D-Link router (I don't even know if my D-Link router supports static routes)?

My configuration is like this:
- Westell - acts as DSL modem only (IP address: 192.168.1.1)
- D-Link DI-614+ Wireless Router - does PPPoE authentication, firewall, routing, DHCP, etc, (IP address: 192.168.0.1)

Since the D-Link thinks anything on the WAN port is Internet and not part of the LAN, when I goto hit 192.168.1.1 I don't find it.

Any help would be much appreciated! My setup is much more stable using my D-Link for wireless versus using the Westell for wireless! Thanks.

Check this here:

»VersaLink+Wireless+Hub with another FireWall

I am not making any promises.

Thanks, that makes sense and sounds like it should work just fine ... I'm going to give it a whirl when I get home. Just gotta make a crossover Ethernet cable.