Accessing 3CRWE554G72 after disabling dhcp
I have setup a 3CRWE554G72--->>wrt54gd-ddwrt in WDS mode with ip addy 192.168.1.1. I disabled the dhcp on the 3CRWE554G72 and enabled remote administration from the whole subnet. I am unable to access the router again through the web interface. Any solutions please
Juke BoxHis Word Never FailsPremiumReviews:
·WOW Internet and..
|reply to nutcr0cker |
Well you need to treat this as if your forgotten you password.
From the 3Com Users Guide.PDF
Password and Reset
to Factory Defaults
If you can browse to the Gateway configuration screen but cannot log on
because you do not know or have forgotten the password, follow the
steps below to reset the Gateway to its factory default configuration.
CAUTION: All your configuration changes will be lost, and you will need
to run the configuration wizard again before you can re-establish your
Gateway connection to the Internet. Also, other computer users will lose
their network connections whilst this process is taking place, so choose a
time when this would be convenient.
1 Remove power from the Gateway.
2 Disconnect all your computers and the cable/DSL modem from the
3 Using a straight through Ethernet cable, connect the Ethernet Cable/DSL
port on the rear of the Gateway to any one of the LAN ports.
4 Re-apply power to the Gateway. The Alert LED will flash as the Gateway
starts up, and after approximately 30 seconds will start to flash more
slowly (typically 2 seconds on, 2 seconds off). Once the Alert LED has
started to flash slowly, remove power from the Gateway.
5 Remove the cable connecting the Cable/DSL port to the LAN port, and
reconnect one of your computers to one of the Gateway LAN ports.
6 Re-apply power to the Gateway, and when the start-up sequence has
completed, browse to:
and run the configuration wizard. You may need to restart your computer
before you attempt this.
7 When the configuration wizard has completed, you may reconnect your
network as it was before.
Do you listen to Tangerine Dream?