cwwny
join:2006-07-25
Brooklyn, NY | reply to DracoFelis
Re: [Equipment] Useful Sipura tricks... I have a Linksys PAP2 device and followed DracoFelis directions to get forward all inbound calls to line2 from line1. Please help......
The phone on line2 actually rings but when I pickup the caller's device is still ringing. So my line1 provider is forwarding my line2user@externaldnsname:5061 to line2 and the phone ring but why does it not pickup?
I have every settings enabled that is documented. The following is my SIP settings and Make Call Without Reg and Ans Call Without Reg both enabled.
Reg Retry Intvl: 30
Reg Retry Long Intvl: 300
Handle VIA received: yes
Handle VIA rport: yes
Insert VIA received: yes
Insert VIA rport: yes
Substitute VIA Addr: yes
Send Resp To Src Port: yes
STUN Enable: yes
STUN Test Enable: yes
STUN Server: stun.sipgate.net:10000
NAT Keep Alive Intvl: 15 |
|
| Does anyone know any tricks to use the remote sipura page, the sipura I have is remote on a slow speed link, when I try to access the sipura page, it opens and cant configure as jumping to different screens takes a while and times out, have used IE, mozilla |
|
| > DracoFelis : since this thread is getting pretty long, to the point where I can't even go through all of it to find out if someone knows the trick to configure the Linksys to have it dial out a remote IP phone on the Net directly... maybe it'd be a good idea to extract the tricks into a single document and make it sticky? |
|
maziloFrom MaziloPremium
join:2002-05-30
Lilburn, GA
kudos:1 | said by vincentdelporte :
maybe it'd be a good idea to extract the tricks into a single document and make it sticky? Well, this may not be a bad idea if you start it out  .
--
Mazi (UK Non-Geo Phone: +44-703-194-2574) |
|
|
|
