| Keep getting 'Failed to find the filesystem ID' on USR8200 Hi,
Thanks for looking and here is the issue I am trying to tackle:
Any time I add any/all of the two external HDs below, USR8200 sees them, lets me partition them and when I start formatting I get 'Failed to find the filesystem ID' in about a minute.
Any suggestion ? Attaching sysLog below.
Cant get any technical guy at the USR Support after opening 4 cases on this issue, I guess they are trying to ignor this case.
THANKS.
The firmware I have is the updated and is of v3.10.20.19
The External drives I have used:
Firewire External drive:
Size: 128.0G
Type: SBP-2 IEEE-1394
Description: Maxtor 1394 storage (Rev: 60)
USB External drives:
Size: 160G
Type: USB2
Description: NexStar USB2.0 (Rev: 0100)
The SysLOG after a rebbot:
Dec 9 19:41:03 2006 System Log Message daemon.info Run
disk utility: /bin/mkdosfs -v -F 32 /dev/sdc1
/dev/sdc1: No such device or address
mkdosfs 2.10 (22 Sep 2003)
Dec 9 19:41:03 2006 System Log Message daemon.info
rg_system_full:260: spawned PID 85
Dec 9 19:41:03 2006 System Log Message daemon.info
rg_system_full:240: /bin/mkdosfs -v -F 32 /dev/sdc1
Dec 9 19:40:13 2006 System Log Message kern.info
RATELIMIT: 1 messages of type IPSec kernel packet reported 120 second(s) ag
Dec 9 19:38:13 2006 System Log Message kern.warn
RATELIMIT: 4 messages of type IPSec kernel packet reported 113 second(s) ag
Dec 9 19:36:56 2006 System Log Message kern.warn I/O
error: dev 08:00, sector 0
Dec 9 19:36:56 2006 System Log Message kern.warn
unable to read partition table
Dec 9 19:36:56 2006 System Log Message kern.warn I/O
error: dev 08:00, sector 0
Dec 9 19:36:56 2006 System Log Message kern.info sda:
I/O error: dev 08:00, sector 0
Dec 9 19:36:56 2006 System Log Message kern.warn sda:
Write Protect is off
Dec 9 19:36:56 2006 System Log Message kern.warn sda :
block size assumed to be 512 bytes, disk size 1GB.
Dec 9 19:36:56 2006 System Log Message kern.warn Raw
sense data:0x70 0x00 0x02 0x00 0x00 0x00 0x00 0x0a 0x00 0x00 0x00 0x00 0x3a 0x00 0x00 0x00 0x00 0x00
Dec 9 19:36:56 2006 System Log Message kern.warn
ASC=3a ASCQ= 0
Dec 9 19:36:56 2006 System Log Message kern.warn
Current sd00:00: sns = 70 2
Dec 9 19:36:56 2006 System Log Message kern.warn sda :
status = 1, message = 00, host = 0, driver = 08
Dec 9 19:36:56 2006 System Log Message kern.warn sda :
READ CAPACITY failed.
Dec 9 19:36:50 2006 System Log Message daemon.info
mt_fsrv_hotplug_notify:270: usb (1):
bus(1),dev(4),vendor(402),prod(5621),rel(109),device(0:0:0)
interface(8:6:80)
Dec 9 19:36:50 2006 System Log Message daemon.warn
mt_hotplug_ipc:249: Unknown parameter received:
DEVFS=/proc/bus/usb
Dec 9 19:36:50 2006 System Log Message kern.debug USB
Mass Storage device found at 4
Dec 9 19:36:50 2006 System Log Message kern.debug
WARNING: USB Mass Storage data integrity not assured |
