Re: Placing CPEs near power lines

Author	All Replies
VariableARK join:2003-03-17 USA	reply to John Galt Re: Placing CPEs near power lines These are high voltage line -> 480kv I believe.
VariableARK join:2003-03-17 USA	to forum · permalink · · 2007-03-05 14:29:30 ·
Keithb join:2003-09-16 US	There is a minimum distance you can be legally to any power-line, and I believe that's 15' so do beware for legality and for safety reasons. We have mounted Satellite arms on our own lift poles right next to secondary service (240v) without any problems. If the wire is covered, it's more than likely =277/480 Anything not covered with insulation is more than likely primary at 7.2kv on up.
Keithb join:2003-09-16 US	to forum · permalink · · 2007-03-05 14:51:33 ·
VariableARK join:2003-03-17 USA	We're not that close. probably around 150' I'll go check the plat tomorrow, I'm too sick today.
VariableARK join:2003-03-17 USA	to forum · permalink · · 2007-03-05 15:17:14 ·
public join:2002-01-19 Santa Clara, CA ·DSL EXTREME	said by VariableARK : We're not that close. probably around 150' I'll go check the plat tomorrow, I'm too sick today. If there are bad effects resetting the radios, it is probably magnetically induced common mode voltage. At 150 ft the effect should be negligible. HV lines do not radiate much beyond 50 MHz.
public join:2002-01-19 Santa Clara, CA ·DSL EXTREME	to forum · permalink · · 2007-03-06 03:48:05 ·


Wednesday, 09-Dec 17:51:27	Terms of Use \| Privacy Policy \| Hosting by www.nac.net - DSL,Hosting & Co-lo \| feedback \| contact over 10 years online! © 1999-2009 dslreports.com. page compression OFF