Re: Placing CPEs near power lines

Forums » Industry Forums » Wireless Service Providers » Placing CPEs near power lines


Share Topic:	RSS topic:	toggle: flat / full normal / watch	Posting:	Post a:	Post a:

Links: ·WISP Forum FAQ ·WISP Directory ·WISP Forum Frappr Map ·Radio Mobile

AOL blocking traffic »
« Pac Wireless Hor-pol Omni acting strange

Keithb

join:2003-09-16
US

Re: Placing CPEs near power lines

There is a minimum distance you can be legally to any power-line, and I believe that's 15' so do beware for legality and for safety reasons. We have mounted Satellite arms on our own lift poles right next to secondary service (240v) without any problems.

If the wire is covered, it's more than likely =277/480

Anything not covered with insulation is more than likely primary at 7.2kv on up.

permalink · 2007-03-05 14:51:33 ·

VariableARK join:2003-03-17 USA	Re: Placing CPEs near power lines We're not that close. probably around 150' I'll go check the plat tomorrow, I'm too sick today.
	permalink · 2007-03-05 15:17:14 ·

public join:2002-01-19 Santa Clara, CA ·DSL EXTREME	Re: Placing CPEs near power lines said by VariableARK : We're not that close. probably around 150' I'll go check the plat tomorrow, I'm too sick today. If there are bad effects resetting the radios, it is probably magnetically induced common mode voltage. At 150 ft the effect should be negligible. HV lines do not radiate much beyond 50 MHz.
	permalink · 2007-03-06 03:48:05 ·

your comment..

Forums » Industry Forums » Wireless Service Providers	AOL blocking traffic » « Pac Wireless Hor-pol Omni acting strange


Wednesday, 09-Dec 08:56:24	Terms of Use \| Privacy Policy \| Hosting by www.nac.net - DSL,Hosting & Co-lo \| feedback \| contact over 10 years online! © 1999-2009 dslreports.com. page compression OFF