Tim618
join:2003-10-14
Garrettsville, OH | reply to Tim618
Re: Phone light goes out anyone? |
|
1 edit | I'm not familiar with the netgear but most routers have a place that you can assign a static IP address and tie it to the MAC address of the unit.
This board may not be the place to get support on your router unless you just happen to run across someone with the same setup.
I'm running a WRT54GL with Tomato firmware so unfortunately I can't help you, sorry. |
|
|
|
dmbmar
join:2006-09-24
Denver, CO | reply to Tim618
Log into your router. On the left-hand side will be a list of functions. Select "LAN settings." On that page, about 1/2 way down, there is an option to set a static IP address for all or any of the devices connected to the router. Select that option, and then select your ATA. Assign it an IP address outside of the range for IP addresses that the router will dynamically set. I think Netgear's default is 192.168.0.X - with #1 being assigned to the router - and a range up to 10 or 20. So pick 192.168.0.25. Hit the refresh key and reboot your ATA. |
|
