|
 
TE
I must crunch
join:2006-05-07
Brea, CA
clubs:
| Re: WRT54G How do I assign a fixed IP ? (simple question) I'm assuming the Linksys PAP2 VOIP device is getting it's address from the WRT54G by DHCP. You can set the router's DHCP to always give the VOIP device the same IP.
»www.google.com/search?hl=en&q=WR···hcp+mac+ | |
|
jp0469
JP
join:2000-12-13
Rochester, MA | You can set a fixed IP right in the configuration pages of the PAP2 itself. Type the current IP address of the PAP2 in a browser to view the config page. In there you will see the option to set a fixed IP. | |
|
rizzo2dial
Premium
join:2004-08-05
| I haven't looked at Linksys' stock firmware in a long time, but when I last looked at it, it did not offer Static DHCP assignments. Only 3rd party firmware, such as DD-WRT, did.
If that's still the case, you'll need to either configure your static IP in the PAP2 (as previously suggested) or switch your WRT54G over to 3rd party firmware. | |
|
 | 
Phil
Rojo Sol
Premium
join:2001-06-11
Camarillo, CA
 ·Verizon FIOS
| Re: WRT54G How do I assign a fixed IP ? (simple question) said by rizzo2dial  :I haven't looked at Linksys' stock firmware in a long time, but when I last looked at it, it did not offer Static DHCP assignments. Only 3rd party firmware, such as DD-WRT, did. This is still the case. | |
|
| |
TE
I must crunch
join:2006-05-07
Brea, CA
clubs: | Re: WRT54G How do I assign a fixed IP ? (simple question) You guys are correct. The stock firmware doesn't support static assignments. My bad. I should have taken a closer look.  | |
|
| | | |
|
|
|
·
·
·