VOIP etc > Voice Over IP - VOIP > VOIP Tech Chat > [General] DLink VTA-VR

reply to mazilo

Re: [General] DLink VTA-VR

Thanks for your reply! I tried your suggestion, but no luck. The device still cannot register.

You have to remember that FWD doesn't support for a Registrar Address server (as of this writing) and my response as shown in the link works just fine with GizmoProject because it does have a support for a Registrar Address server.

You certainly can build your own Registrar Address server running on your NAT/Firewall router for your ATA devices to use if your NAT/Firewall router is supported by any open-source firmware as shown here. I know this because I had my Linksys WRT54GS v3 NAT/Firewall router running a DDWRT open-source firmware with its VoIP package acting as my own Registrar Address server for my Linksys/Vonage WRTP54G WiFi VoIP router, Linksys PAP2v2, and DLink VTA-VR devices registered to VoSPs that don't support for a Registrar Address server, i.e. FWD, VoIPUSer, etc.

Thanks! I switched to GizmoProject so I can get the VTA-VR work. I hope I can get Linksys PAP2 work with GizmoProject too so that I can build a hot line between my family members.