| [Equipment] PAP2 v2 SIP Config Settings I recently unlocked my PAP2 v2 device for use with my CentPBX, and after reading thru this post:
»www.aussievoip.com/wiki/Resolvin···onflicts
I realize that same of the setting w/in the PAP2 conflict with Asterisk. The problem with the aforementioned post is that it's for PAP2 v1, and I am using
v2. So my settings don't look the same.
I need some help getting the proper settings for my PAP2 so that it will work with my CentPBX, here are some screenshots
of the PAP2 settings:
I also read in "TrixBox Without Tears v2": quote:
Under Dial Plan, change the
existing dial plan to (**|*x.|x.) Change Enable IP Dialling to yes."
Is Dial Plan the same as "Digit Map"?
And if so do I place "(**|*x.|x.)" including the parentheses?
Also I don't see IP Dialling anywhere in my settings?
Please help, or at least direct me to info on this.
Thanks,
-BassKozz |
|
maziloFrom MaziloPremium
join:2002-05-30
Lilburn, GA
kudos:1
1 edit | said by BassKozz:Is Dial Plan the same as "Digit Map"? In plain English, a dial plan is NOT the same as a digit map. AFAIK, the task of a digit map just simply maps a digit. |
|
| Ok what about the rest of the settings? |
|
maziloFrom MaziloPremium
join:2002-05-30
Lilburn, GA
kudos:1 | said by BassKozz:Ok what about the rest of the settings? I don't have a PAP2v2 configured to operate on my LAN at the moment; however, the dial plan from my Uniden UIP1869V Digital IP Phone which I believe is similar to the one from a PAP2v2 is follows:
*xxT|*1xx|[349]11|1xxx[2-9]xxxxxx|[2-9]xxxxxxT|[2-9]xxxxxxxxx|011x.T
The above dial plan is the default one and it is working just fine for me with GizmoProject, i.e. I haven't tried it on any commercial VoSPs, yet. |
|
|
|
