offshoretech
@pldt.net
| reply to Qwest2701HG
Re: Problems with Qwest 2-Wire 2701HG - Does not support QOS...
just got back to my workstation today,
ok, this may be too late but here is a level 1's take on your problem
there was a bug on the 2700HG-D firmware regarding SIP ALG and documentation said it was already corrected, the correction may not have carried over to the 2701HG-D firmware though.
as per documentation, you have to open up the 192.168.0.1/mdc page, go to the ADVANCED heading on the LEFT PANE and choose CONFIGURE SERVICES, UNSELECT the CHECKBOX next to “SIP Application Layer Gateway”, press on SUBMIT and you will be taken back to the 192.168.0.1/mdc main page. at this point you have to reboot ATA.
current firmware version may have the SIP Application Layer Gateway already UNCHECKED, if so CHECK it first, SUBMIT and open up the 192.168.0.1/mdc page again and this time UNCHECK and then SUBMIT. reboot ATA.
hope this helps. |
