http://www.dslreports.com/forum/r19674132 en Thu, 04 Dec 2008 22:36:25 EDT Thu, 04 Dec 2008 22:36:25 EDT http://www.dslreports.com/forum/remark,19674132 Splitpair : The problem I think you are going to run into with a PRI is you will need a device that can simulate a CO DS1 switch port toproperly communicate with the router on the D channel. For a basic rate you can do that with a TPI 550B+ »cgi.ebay.com/TTC-Acterna-TPI-550···ViewItem

BTW that price is way over the top I have seen 550's going for a little as $200 on ebay.

Wayne
--
If you cannot fix it with a buttset and some beanies you ain't a technician.]]> http://www.dslreports.com/forum/remark,19674132 Sun, 23 Dec 2007 10:59:07 EDT http://www.dslreports.com/forum/remark,19396172 zillah : I am looking to do a test at a lab (to simulate a real life design). I have got two routers, each router has got PRI 2CE1B interface card.

Can I connect these tow router by using :

E1 Interface Cable for 120-Ohm, Balanced Connections (with DB-15 Connector),to simulate ISBN PRI connection ?? or I have to buy an ISDN simulator for this purpose ?

Similarly If I want to simulate BRI between two routers (that have BRI Interface card) , can I use a specific cable for that ? or also I need to buy simulator ?

Regards]]> http://www.dslreports.com/forum/remark,19396172 Tue, 06 Nov 2007 20:11:44 EDT