troll5501
join:2007-12-11
Wilmington, DE
| reply to Rattler
Re: Mounting board for 612 ONT?
I've got the 611 + BBU all installed inside. I believe it's the same size as the 612. Entire unit is approximately 12" x 20". Attached is a picture. |
|
antioch
join:2007-10-06
Pomona, CA | run that gray cat5e behind the board, it'll keep it out of the way and hide it too... just a recommendation =D |
|
troll5501
join:2007-12-11
Wilmington, DE
| said by antioch  :run that gray cat5e behind the board, it'll keep it out of the way and hide it too... just a recommendation =D Someday I'll re-route it. Still trying to get my office put together. Currently the cable is running out of the storage closet from the ONT and halfway across the room to my router, temporary, of course...  |
|
Rattler
join:2001-04-13
Havertown, PA
 ·Verizon Online DSL
 ·Verizon FIOS
| Thanks, troll5501...
The mounting board in your photo looks like it might be 24" x 24"?
If the tech mounts the ONT about 1/2" from the left edge of my board, there should be plenty of room for a single duplex outlet at the upper right hand corner of it.
--
Never raise your hands to your kids. It leaves your groin unprotected. -- Red Buttons |
|
troll5501
join:2007-12-11
Wilmington, DE
| said by Rattler :The mounting board in your photo looks like it might be 24" x 24"? My mounting board is about 18" x 20". The ONT is just about flush with the top and bottom of it. Keep in mind that the cabling will enter from the bottom so you should allow room for that. |
|
Rattler
join:2001-04-13
Havertown, PA
·Verizon Online DSL
·Verizon FIOS
| said by troll5501 :My mounting board is about 18" x 20". The ONT is just about flush with the top and bottom of it. Keep in mind that the cabling will enter from the bottom so you should allow room for that. OK, thanks. There should be plenty of room on the 17" x 26" board - that helped a lot.
--
Never raise your hands to your kids. It leaves your groin unprotected. -- Red Buttons |
|
troll5501
join:2007-12-11
Wilmington, DE
| said by Rattler : OK, thanks. There should be plenty of room on the 17" x 26" board - that helped a lot. FYI, the black cable at the bottom of the picture is the VZ fiber cable. It drops from the top, and the installer routed it behind the board (in the space between the wall studs) and looped it back up from bottom and into the ONT. |
|
