1 edit | reply to More Fiber
Re: Help - How to reconfigure AT IP Pool? Thanks for replying. I am aware that they are on different subnets, see where I reconfigured the AT into the 0.* pool to match that of the Buffalo. It was this configuration that restricted all access to the AT unless I was plugged directly into it(I have disabled the wireless antenna). That is the gist of my posting, i.e. why I can't get internet/lan connectivity if I am connected to the buffalo even though they are both in the same IP pool.
I will give your suggestions a try. A question, in order to bypass the paltry NAT table on the AT would my only option be to put the AT behind the buffalo?
Also, is the ethernet port on the ONT accessible? I would need to run a much longer cable from it to reach the Buffalo if I were to put the AT behind the buffalo. |
