www.broadbandreports.com
  
Search:  

 
   AllHot TopicsCable SupportTelco SupportHardware etcSecurityClubsGallery»»






how-to block ads


 
Forums » US Cable Support » Cable users » cableone service tv/lan one line to rule them all. hmm
 
Search Topic:
  Social:
topic feed
 
Posting
toggle:
flat / full
normal / watch
Post a:
Post a:
Need supplier of small quantities of CommScope .75 connector »
« Questions about a popular speed test- Ping, and ranking, etc  
AuthorAll Replies

gremloc

join:2006-10-24
Long Beach, MS

cableone service tv/lan one line to rule them all. hmm

Now heres the thing about our cable. I know its easier to run both services into one line. However your paying for two different services, cable tv and cable network. Now if you go by what you pay then you and everyone else should have two seperate lines into your house and service should be setup that way. Our neighborhood is not setup that way and i was wondering if anyone else felt the same way about this. If i m paying over a hundred dollars for this service and only one line then the rate of data collision go's way up. Ergo slower capacity and lag time results, and also degraded picture on the cable channels.


craig70130
Premium
join:2004-04-27
New Orleans, LA
Doesn't work that way. Totally different set of frequencies.


tschmidt
Premium,MVM
join:2000-11-12
Milford, NH
·Verizon Online DSL

reply to gremloc
I think you are confusing Collision based Ethernet with Cable TV.

Cable TV as with over-the-air TV uses 6 MHz channels (in US). When the Cable system was modified to support high-speed Internet access digital modulation techniques were developed that allows each 6 MHz channel to deliver about 42 Mbps of data. Currently only one channel per node is used but the newest DOCSIS version allows multiple channels be bonded for higher speed.

Upload was a problem since except for limited SCADA telemetry data cable systems had no need to transmit data back to the head-end. In fact some early cable systems used dial-up modems to send data back to the head end. Modern systems allow customer data be sent back the the head-end. Customer data is transmitted at lower frequency then used by TV channels. Limited speed of transmit channel is why Cable Operators are so aggressive prohibiting so-called bandwidth hogs.

Here is a link to Wikipedia for more background:
»en.wikipedia.org/wiki/Docsis
/tom


AZwldcats
Ummm That's Right

join:2001-02-20
Tucson, AZ
clubs:
reply to gremloc
Plus to point out.... You could have 1000 seperate lines coming into your house... it all goes back to one line at the plant...

It isn;t like a telco where every house has a dedicated line going to it...
Forums » US Cable Support » Cable usersNeed supplier of small quantities of CommScope .75 connector »
« Questions about a popular speed test- Ping, and ranking, etc  

Most commented news this week
· [153] Comcast Van Race Injures 3-Year-Old
· [99] EA Scales Back 'Internet Required' DRM
· [82] Sprint Hemorrhaging Wireless Subscribers
· [74] ISPs To Start Booting More P2P Users
· [74] Mozilla Considering Opt-In Browsing Tracking
· [70] Canadian Regulators Deny Relief For Bell Canada Traffic Shaping
· [57] Baby Bell Neglect of Vanilla DSL Could Spell Trouble
· [52] An Inside Look At RIAA DMCA Letter Generation
· [51] Missouri University Makes Kids Take Copyright Quiz To Use P2P
· [48] Verizon: Stop Yer Broadband Bellyachin'
Saturday, 17-May
05:33:55
Terms of Use | Privacy Policy | Hosting by www.nac.net - DSL,Hosting & Co-lo | feedback | contact
8th year online! © 1999-2008 dslreports.com.republican-creole
page compression OFF