bigunk
Gort, Klattu Birada Nikto
join:2001-02-10
Santa Clarita, CA | reply to jgkolt
Re: opendns
Just give me a way to turn one of these things into a bridge, so I can use a real router to deal with my network. |
|
EmpireDD
join:2004-08-25
Bedford, TX
| I am with you. I use Sonicwall Pro 2040. I have to set it up with the Sonicwall inside the 2Wire using their DHCP and NAT. I would like to(Bridge)pass all ports and IPs through to the firewall so I can incorporate my own NAT, Stateful Pk Inspection,Authentication ... etc.
I have noticed my public IP has remained the same since install. I sure could use one more to assign to the firewall for hardware VPN on the Sonicwall. Can anyone give me some advice on this? |
|
BeeTea1250
join:2006-06-08
UK
| said by EmpireDD  :I am with you. I use Sonicwall Pro 2040. I have to set it up with the Sonicwall inside the 2Wire using their DHCP and NAT. I would like to(Bridge)pass all ports and IPs through to the firewall so I can incorporate my own NAT, Stateful Pk Inspection,Authentication ... etc. I have noticed my public IP has remained the same since install. I sure could use one more to assign to the firewall for hardware VPN on the Sonicwall. Can anyone give me some advice on this? »2 Wire »Bridging the 2wire and PPPoE (Disabling Router) |
|
Airwolf7
Premium
join:2004-12-12
Franklin, KY
 ·AT&T Southeast
| reply to bigunk
I don't know which 2Wire model you have but below is a FAQ describing how to "Bridge" a 2Wire 2701HG-B Wireless Gateway.
»AT&T Southeast Forum FAQ »Bridge Mode for the 2Wire 2701HG-B |
|
Empire DD
@pacbell.net
| Thanks for the timely response. I still have the same problem because I have a 2Wire 3800HGV-B which does not resemble the other 2WIREs. I am unable to find the commands to turn off NAT, DHCP and turn off Bridging. I may be entering the console from the wrong place but I have used the /management or /mdc and the console does not give me the options neccessary to change the bridging.
Thanks in advance |
|
