drpain
join:2008-02-08
| switch cannot boot i rebooted my cisco 4503 switch then it went to rommon mode.
normally when it prompts me to this mode i usually type boot then it boot.
Now the issue is i cannot type anything in hyper terminal window yet my keyboard is working.
any idea of what is happening and how i can resolve it | |
|
 
Domwilko
CCVP, CCNP, CCNA, CCDA
join:2002-03-02
UK | Re: switch cannot boot What's the output when you type 'set' from ROMMON?
--
Domwilko - CCVP, CCNP, CCNA, CCDA | |
|
 | drpain
join:2008-02-08 | Re: switch cannot boot no output appears. It appears as if the keystrokes are not registering | |
|
| | 
rolande
Certifiable
Premium,Mod
join:2002-05-24
Powell, OH
clubs:
Host:
Linksys
AT&T Midwest
| Re: switch cannot boot It is possible that the config-register got changed on the switch which adjusted the console port speed settings. Typically you might see garbage on the terminal client if the console port is running at higher speed. Unfortunately, if that is the case, the only way to recover is to guess the line speed by manual testing.
Have you verified that the switch port lights are not lit amber and staying that way through the POST? You should see the lights flash as it is booting.
--
Ignorance is temporary...stupidity lasts forever!
»www.thewaystation.com/
»blog.thewaystation.com/ | |
|
| | kubaff
join:2007-06-14
kenya |
Did you adjust the config register to 0x2102 ? | |
|
| | kubaff
join:2007-06-14
kenya |
Did you adjust the config register ? | |
|
|
drpain
join:2008-02-08 | nomally when it prompts me to ROMMON Mode i just type boot and that is it. it boots fine but now i cannot type any letter. How can i resolve this
please assist. | |
|
|
rolande
Certifiable
Premium,Mod
join:2002-05-24
Powell, OH
clubs:
Host:
Linksys
AT&T Midwest
1 edit | Re: switch cannot boot You're not reading my post. I am not talking about the switch configuration. I am talking about your terminal client on your PC. If you can see the text output on the terminal screen but when you type nothing shows up, then you either have an incorrect flow control setting in your terminal client, local echo is disabled, or there is a bad pinout on your terminal cable.
Also you can fix this issue of the switch booting to ROMMON by adjusting the config-register to 0x2102 and/or configuring 'boot system flash:imagename.bin'. Do a dir on your flash to see what IOS image is booting and you can configure that manually to boot at startup so you don't have to do it yourself each time. | |
|
|
|
|
