[Temps] Q6600 Higher Temps in Overclocking/Modding http://www.dslreports.com/forum/r20377250 en Sun, 12 Oct 2008 11:06:27 EDT Sun, 12 Oct 2008 11:06:27 EDT Re: [Temps] Q6600 Higher Temps http://www.dslreports.com/forum/remark,20844144 Sc0tt : here's my temps at basically idle in an 80* room.........

using AC freezer pro7 cooler with fan at 1900RPM. core is set to 1.22 volts.
]]> http://www.dslreports.com/forum/remark,20844144 Thu, 24 Jul 2008 18:33:43 EDT Re: [Temps] Q6600 Higher Temps http://www.dslreports.com/forum/remark,20784030 ryang : Previous idle was around 45-50C..
I just upgraded from a cramped Antec LanBoy case to an Antec 1200. Stock intel HSF.
]]> http://www.dslreports.com/forum/remark,20784030 Sun, 13 Jul 2008 11:02:56 EDT Re: [Temps] Q6600 Higher Temps http://www.dslreports.com/forum/remark,20766617 BarneyBadAss :
said by NYR11 See Profile :

BBA those are some nice temps. Is that with the stock intel heatsink?
Thanks... I suspect I could do better but this works..

nope.. not the stock heat sink..

it's a thermalright 120 Extreme with a 120 panaflex fan attached as the cpu fan.. see it here:

»2cooltek.com/panasonic-panaflo-f···1bx.html

I also have 6 case fans... 5 80MM and 1 92mm.

3 80mm fans are pull from the front to the back across my HDD's; 2 80mm fans push (typical exhaust) and 1 92mm fan that also pushes... (exhaust)..

There's a lot of air flow through this case.
--
---Barney]]> http://www.dslreports.com/forum/remark,20766617 Wed, 09 Jul 2008 20:08:05 EDT Re: [Temps] Q6600 Higher Temps http://www.dslreports.com/forum/remark,20749718 NYR11 : BBA those are some nice temps. Is that with the stock intel heatsink?]]> http://www.dslreports.com/forum/remark,20749718 Sun, 06 Jul 2008 17:12:29 EDT Re: [Temps] Q6600 Higher Temps http://www.dslreports.com/forum/remark,20745526 BarneyBadAss : I don't know about the rest of you; but here's what my temps look like and this is on AIR
--
---Barney

no load on CPU		 

Full Load after 6 hrs		 
]]> http://www.dslreports.com/forum/remark,20745526 Sat, 05 Jul 2008 13:51:54 EDT Re: [Temps] Q6600 Higher Temps http://www.dslreports.com/forum/remark,20609783 NYR11 : I see you people are using a V core of 1.2375 for your Q6600's and overclocking it to 3.2. My gigabyte ep35 ds3p board uses 1.3 v core as "normal" voltage for the stock speed of 2.4. Well anyway, some overclocking forums that I have read recommended 1.4 vcore. When I did that my temps at even 2.7(9x300) went into the high 50's under load with the stock Intel heatsink. Well I tried the 1.2375 vcore that you are using and bumped the cpu up to 3.0(9x333) and it is running just fine. Temps at idle are mid to high 30's and never hitting 50 under load playing Crysis and CS. I'm happy with it at 3.0 especially with stock cooling. May fiddle with RAM timings a bit now to really get it tweaked. Thanks for posting the low vcore stats :)
--
"It's a nice day if you wake up in Disneyland"]]> http://www.dslreports.com/forum/remark,20609783 Sun, 08 Jun 2008 05:59:08 EDT Re: [Temps] Q6600 Higher Temps http://www.dslreports.com/forum/remark,20416514 Ryan : WOW i was looking at the b3 temps the entire time. Just found their g0 temps listed

Q6x00: Tcase Max 71c, Stepping G0

-Tcase/Tjunction-
--70--/--75--75--75--75-- Hot
--65--/--70--70--70--70-- Warm
--60--/--65--65--65--65-- Safe
--25--/--30--30--30--30-- Cool

Makes me feel a hell of a lot better since i am between safe and cool at full load with prime. Guess I am being paranoid! :)]]> http://www.dslreports.com/forum/remark,20416514 Thu, 01 May 2008 13:29:27 EDT Re: [Temps] Q6600 Higher Temps http://www.dslreports.com/forum/remark,20409625 keno5net : Here is a great link (which I got from reading this forum originally) on temperatures in Intel processors including a procedure for calibrating the sensor.

»www.tomshardware.com/forum/22174···re-guide

One problem as I see it is the wildly differing readings from various temperature reading software making one persons 50 degrees the same as another persons 75 degrees.

After reading that link I went out and got a Thermalright ultima-90 cooler and a PWM fan and that dropped my temps by 15 degrees C and is quieter than the stock HSF. My Q6600 G0 is still only at 3Ghz because I am cautious but it may be pushed a little more in the future.]]> http://www.dslreports.com/forum/remark,20409625 Wed, 30 Apr 2008 08:28:04 EDT Re: [Temps] Q6600 Higher Temps http://www.dslreports.com/forum/remark,20399342 Gooiool : I believe that is the overall chip temperature.
About core temps I wouldn't that concerned about them as most say it's the overall you need to look at .
For that matter this is my Stock Dell :o
AMD Athlon 64 X2 5000+ hardware monitor
{and room temp is 65f today }
Temperature sensor 0 54°C (129°F) [0x67] (core #0)
Temperature sensor 1 62°C (143°F) [0x6F] (core #1)
I know AMD's run hotter and this things been at these temps since day one , almost a year so far . ;)
--
Team DiscoveryJoin us help fight cancer.
Gooiool©2005 My Photo Site]]> http://www.dslreports.com/forum/remark,20399342 Mon, 28 Apr 2008 11:59:41 EDT Re: [Temps] Q6600 Higher Temps http://www.dslreports.com/forum/remark,20396053 Ryan :
said by Gooiool See Profile :

ENVIRONMENTAL CONDITIONS
Temperature 71. °C (159.8 °F) :o
Yea I have seen that one before too it does make me feel soemewhat better, but one thing though about that temp are they referring to a single core temperature or the actual overall chip temperature? If its chip temperature then i am absolutely not worried since it only hits like 53ish. I guess either way without running prime I really only see it hit in the low 50's.]]> http://www.dslreports.com/forum/remark,20396053 Sun, 27 Apr 2008 17:40:06 EDT Re: [Temps] Q6600 Higher Temps http://www.dslreports.com/forum/remark,20395097 Gooiool : ENVIRONMENTAL CONDITIONS
Temperature 71. °C (159.8 °F) :o

I used to worry to until I seen this .
]]> http://www.dslreports.com/forum/remark,20395097 Sun, 27 Apr 2008 13:25:53 EDT Re: [Temps] Q6600 Higher Temps http://www.dslreports.com/forum/remark,20381189 Ryan : Guess I am being paranoid then? I always thought 50 as being hot...

Yea typo above on the oc voltage. My vid is the same as yours glen 1.2375 which from what I have been reading is pretty low. I wish I could run at 1.275 since at that temp it ran a good 6 degrees lower, but it failed prime 8 hours after testing. ]]> http://www.dslreports.com/forum/remark,20381189 Thu, 24 Apr 2008 17:13:37 EDT Re: [Temps] Q6600 Higher Temps http://www.dslreports.com/forum/remark,20377747 GlennH : That doesn't seem too bad. I'm also running my q6600 at 3.2GHz but need 1.275v (what's your VID? Mine's 1.2375) but my temps at load are 59-57-57-58. I did install a XIGMATEK HDT-S1283 and used AS5.]]> http://www.dslreports.com/forum/remark,20377747 Thu, 24 Apr 2008 01:01:22 EDT Re: [Temps] Q6600 Higher Temps http://www.dslreports.com/forum/remark,20377686 CCat : I wish I could get mine to run that cool. I dont believe you have anything to worry about.
--
Graphics Playground]]> http://www.dslreports.com/forum/remark,20377686 Thu, 24 Apr 2008 00:40:09 EDT [Temps] Q6600 Higher Temps http://www.dslreports.com/forum/remark,20377250 Ryan : Argh man thought I was doing good with my temps, but with the 85 degree weather today and with the higher ambient temps my q6600 temps went up :( Running my q6600 G0 at 3.2ghz 1.28v and when i start up prime95 it now hits 63 , 63 , 58 , 58. :( Should I lower the overclock? Seems like such high temps to me since many people hit 3.4-3.6 with similar temperatures. We do have central air which wont kick on for a little while, but I am concerned about the life of the processor with these temps. Starting to think about reseating my heatsink, but not sure if that will even help. Oh Idle its at 40, 37, 33, 37...]]> http://www.dslreports.com/forum/remark,20377250 Wed, 23 Apr 2008 22:50:48 EDT