AmirK
@comcast.net | Linksys PAP2 Phone Adapter for Vonage Internet Phone Service
Hello, I just bought PAP2 and wondering how I can wire it so that all lines in the house could get activated.
Thank you |
|
eakes
join:2000-10-20
Richardson, TX
| It's rather simple. Make sure the cable from the telephone company is disconnected from the house telephone lines. There is normally a box located on an outside wall of the house where this line connects to the inside wiring - disconnect the line from the telco. Once that is done connect the active line from the PhoneAdapter to a phone wall outlet. If you need a telephone to plug in at the same point, get a line splitter, plug it into the wall outlet, the PA into one side and the phone into the other. |
|
n1zuk
My wood is stacked
Premium
join:2001-10-24
South Burlington, VT | reply to AmirK
All you would ever wish to know:
»voip.mi-telecom.org/ |
|
AmirK
@comcast.net | reply to AmirK
Very good website however can not digest it. Ca any one please summaries it what I need to do? |
|
UglyDork
Premium
join:2002-01-09
Buffalo, NY
 ·Vonage
| 
Example of NID |
2. Disconnect the main Telco line coming into that box.
3. Connect Vonage adapter into any phone jack in the house.
That's it. Configure Vonage per the instructions.
For instructions on how to disconnect the main Telco line, please open the 'customer side' of the NID and post a picture of it.
**Some older homes don't have a NID. If that's the case, the steps will be slightly different. Post of pic of that if you need to as well. |
|
AmirK
@davita.com | reply to AmirK
Unable to locate the box so far. I did find one but it is I think for security system. I will continue to look for it. |
|
