said by Airwolf7 
:You already have a wireless router that you have been using with your Comcast HSI service so there is no need to waste money on additional networking equipment.
After you have properly configured your DSL modem and wireless router your wireless router will be in charge and doing all the work. Your DSL modem will be acting as a "Bridge Modem" and will only be modulating and demodulating the DSL signal. The only reason that you would need to check your modem's "DSL Statistics" page would be if you are having DSL synchronisation problems and need to troubleshoot these problems.
.
.
.
Disconnect your wireless router from your computer and cable modem and set it aside for latter.
Follow the instructions provided with you DSL modem and installation kit to setup your DSL service and activate your account.
Make sure to write down and store in a safe place your FastAccess DSL login user name and password for future reference. You will be using this information latter while configuring your modem for "Bridged Ethernet" mode and configuring your wireless router for "PPPoE" mode. Your user name must be in the format of
username@bellsouth.net and your password is case sensitive.
When you are finished with setting your FastAccess DSL service up you can check your modem's "DSL Statistics" page at the address below.
»
AT&T Southeast Forum FAQ »
How do I access the 2210 line stats and event logs? What do the numbers mean?.
.
.
I have to go because I have been called out on a job.
You do not need to buy any equipment because you already have what you need for the job at hand.
Please check out the Motorola FAQ for more information about the Motorola Netopia 2210-02-1006.
»
AT&T Southeast Forum FAQWhat make, model, and version wireless router do you have?
USR MaxG USR5461..latest firmware 3.93.35.0.8 and it does have built in PPPoE.
·
·
·
