Da Geek Kid
join:2003-10-11
Mclean, VA | reply to panagioti9
Re: [Config] QOS for Cisco 800 w/ Dialer interfaces using NBAR
post your show ip nbar prot |
|
panagioti9
join:2004-08-16
Richmond Hill, ON
| Notice how the diealer1-rdp-input doesn't come anywhere near to matching the number of ethernet0-rdp-output.(or not at all)
>sh ip nbar protocol-discovery stat bit-rate top-n 5
Ethernet0
Input Output
----- ------
Protocol 5min Bit Rate (bps) 5min Bit Rate (bps)
------------------------ ------------------------ ------------------------
rdp 15000 30000
dhcp 0 0
ntp 0 0
bgp 0 0
cuseeme 0 0
unknown 1000 1000
Total 16000 31000
Dialer1
Input Output
----- ------
Protocol 5min Bit Rate (bps) 5min Bit Rate (bps)
------------------------ ------------------------ ------------------------
rdp 0 15000
icmp 1000 0
ssh 0 0
snmp 0 0
ntp 0 0
unknown 0 1000
Total 1000 16000 |
|
panagioti9
join:2004-08-16
Richmond Hill, ON
| Here is some more consistent inconsistency.(I just turned on protocol discovery for this particular router 10 minutes before)
sh ip nbar protocol-discovery stat byte-count protocol rdp
Ethernet0
Input Output
----- ------
Protocol Byte Count Byte Count
------------------------ ------------------------ ------------------------
rdp 895138 5044546
unknown 76220 79759
Total 1019470 5160126
Dialer1
Input Output
----- ------
Protocol Byte Count Byte Count
------------------------ ------------------------ ------------------------
rdp 0 1091328
unknown 0 90961
Total 84984 1186349 |
|
