bakerj
join:2007-07-16
Chesapeake, VA
1 edit | Grandstream HT-502 7+10+11 Digit Dial Plan?
Does anyone know whether it's possible to configure a Grandstream HandyTone HT-502 for 7, 10 and 11 digit dialing? I can configure it for either 7 & 11 or 10 & 11 digit dialing, but cannot get all three to work and didn't know if I was missing something.
Thanks,
Jason |
|
ChuckIL9
join:2005-11-07
Peoria, IL
 ·magicjack.com
·STANAPHONE
·Aretta Communicati..
1 edit | As far as I know, 7 & 10 digit dialing in the dialplan cannot co-exist with the current firmware. Of course, it doesn't really matter too much. Any dialed string that does not match the dialplan is sent out 4 seconds after the last key press. I just put entries for 10 digit dialing and tell users that the number they dial will connect faster if they use 10 digit dialing. |
|
PX Eliezer
Premium
join:2008-08-09
New Jersey
·voip.ms
·Callcentric
·Optimum Voice
·callwithus
1 edit | reply to bakerj
What dial plan are you using??
Also, I am attaching as a document a dial plan that perhaps may work. Replace the "617" with your local area code.
Good luck. |
|
ChuckIL9
join:2005-11-07
Peoria, IL | I'm pretty sure I tried it that way, and it just truncates off the last three characters and adds the "617" prefix when dialing ten digits. |
|
bakerj
join:2007-07-16
Chesapeake, VA
1 edit | reply to bakerj
said by PX Eliezer  :What dial plan are you using? After failing to get 7+10+11 digit dialing working originally, I settled on:
which is 10 + 11 digit dialing, although I've also used:
which is 7 + 11 digit dialing.
Thanks so much for your suggestion, although sadly I get the same result that I had before; I can either get 7 or 10 digit dialing to work but not both. When I put your suggestion into the dial plan, 7 + 11 works but CallCentric gives me a busy signal when I attempt 10 digit dialing. Perhaps ChuckIL9 is right and 7 & 10 digit dialing cannot co-exist with the current firmware, but I figured I'd ask around before giving up again.
Thanks,
Jason |
|
