Doctor Olds
I Need A Remedy For What's Ailing Me.
Premium,VIP
join:2001-04-19
1970 442 W30
clubs:
| Are you sure you have the P645M-11 Bridge Modem and not the P645-UHP Modem? What does it say on the Label on the bottom of the ZyXEL Modem?
ZyXEL ADSL Modem Label Example
Now if the label shows Prestige 645 - UHP then forget Telnet and follow the steps here:
»EarthLink DSL FAQ »How to Get to the Logs, the Diagnostics Page, and the DSL Statistics Page - UHP
If it says Prestige 645M Bridge Modem then you use Telnet.
Telnet is a Window Application reachable by typing "Telnet 192.168.1.1" in a Run Box minus the quotes of course.
Start Run Dialog
Telnet Command
You must be disconnected from the Internet with no PPPoE software active (the phone cord connected, but no PPP Software running) and with a direct Ethernet connection to the ZyXEL ADSL Modem from the PC with no Router in between.
You set your PC to a Static IP of 192.168.1.10, subnet 255.255.0.0. and Gateway of 192.168.1.1 and click OK until changes are saved. Password is "mspgzyx" minus the quotes as seen in this FAQ. All software firewalls must be disabled or off.
Here are others that have used telnet successfully.
»[Speed Problem] What is my true downstream/upstream cap?
quote:
inside:
Upstream Speed: 768 kbps
Downstream Speed: 3584 kbps
ChangeMe> w a l n
relative capacity occupation: 97%
noise margin downstream: 5.5 db
output power upstream: 12.0 dbm
attenuation downstream: 51.0 db
ChangeMe> w a l f
relative capacity occupation: 104%
noise margin upstream: 7.0 db
output power downstream: 20.0 dbm
attenuation upstream: 31.5 db
------------------------------------
at NID:
Upstream Speed: 512 kbps
Downstream Speed: 2496 kbps
ChangeMe> w a l n
relative capacity occupation: 47%
noise margin downstream: 16.5 db
output power upstream: 10.5 dbm
attenuation downstream: 48.0 db
ChangeMe> w a l f
relative capacity occupation: 62%
noise margin upstream: 16.0 db
output power downstream: 16.5 dbm
attenuation upstream: 29.0 db
»Access Zyxel 645
»upgrading firmware on earthlink dsl ZYXEL P645M
»Re: ZyXel 645
quote:
Go to Menu 24.8 ("Command Interpreter Mode"). Here's the commands to completely snapshot your connection:
w a l n (short for "wan adsl linedata near")
w a l f (short for "wan adsl linedata far")
w a c (short for "wan adsl chandata")
w a p (short for "wan adsl perfdata")
The password "mspzyx" may have been short-lived as is access via telnet.
Upgrading firmware has risk (there's no easily available serial port to fall back on, you better know your settings, Earthlink no longer supports the modem, etc.) There's also a few ways to do it - Menu 24.7.1 is a key.
[text was edited by author 2003-04-18 06:56:48]
Regards,
Doctor Olds
--
What’s the point of owning a supercar if you can’t scare yourself stupid from time to time? |
