dslreports logo
 
    All Forums Hot Topics Gallery
spc
uniqs
14
SipSizzurp
Fo' Shizzle
Premium Member
join:2005-12-28
Houston, TX

SipSizzurp to avibp

Premium Member

to avibp

Re: RV Park Wireless Network Architecture

said by avibp:

I DISagree:
1. Acces points's 4 point distribution because
additional Cat5 will have to be installed all over
the park. I won't be authorized to use multiple
locations and thus the resoning behind "no bridges"
I was not planning to have you run CAT5 anywhere, but to use WDS mode for the distribution channel.

The single location restriction is not good. You need a bare minimum of 3 access points for the quantity of users. Access points start crapping out at about 20 connected users regardless of signal strength or bandwidth consumption. If you can get a 40 foot pole up in the center of the compound it would be an ideal setup with a 3 sector antenna array. This one with individual feed option and three of the deliberant radios would work very well in the center of the park if you can keep the number of users to below 25 per antenna at any given time.
»www.hyperlinktech.com/it ··· x?id=612
avibp
join:2008-10-27
Yuma, AZ

avibp

Member

I am almost liking this... With reading comprehension level being low, I am re-re-re-reading this.