Re: [Packet8] Setting up a BPG510 on Router w/ Tomato Firmware

Author	All Replies
boatman9 join:2003-07-28 Portland, OR	reply to payman Re: [Packet8] Setting up a BPG510 on Router w/ Tomato Firmware said by payman : If there is an unreliable component in my setup which requires reboots every now and then, it's the BPG510. The unreliable component could be the WHR-HP-G54 firmware. If the the WHR-HP-G54 failed to keep a NAT session open then inbound SIP packets would not reach the BPG510, consequently you would not receive inbound calls during that time.
boatman9 join:2003-07-28 Portland, OR	to forum · permalink · · 2008-11-24 15:53:29 ·
payman join:2000-11-04 Bellevue, WA	said by boatman9 : The unreliable component could be the WHR-HP-G54 firmware. If the the WHR-HP-G54 failed to keep a NAT session open then inbound SIP packets would not reach the BPG510, consequently you would not receive inbound calls during that time. This is true and I agree. However as best as I've been able to determine, the router keeps NAT sessions open for very long times (days) with no problems whatsoever. For example I've never seen a disconnected message from a SSH terminal which is open 24/7, and even when I am not receiving incoming calls, I can access the Internet fine (web/SSH/...). There is no need to reboot the router; only to reboot the adapter.
payman join:2000-11-04 Bellevue, WA	to forum · permalink · · 2008-11-25 20:03:45 ·


Wednesday, 09-Dec 10:24:15	Terms of Use \| Privacy Policy \| Hosting by www.nac.net - DSL,Hosting & Co-lo \| feedback \| contact over 10 years online! © 1999-2009 dslreports.com.republican-creole page compression OFF