Thane_Bitter
join:2005-01-20
London, ON
 ·Bell Sympatico
| reply to GeekNJ
Re: BEFSR41
said by GeekNJ  :DHCP only matters if using the WAN port. The WAN side of that model router can only have a static IP, or have one assigned to it by a DHCP server (I will ignore PPPoE, PPTP since they are not relevant in this discussion); it lacks the architecture for generating address (i.e. no DHCP server functions). The LAN side on the other hand does include a DHCP server (and usually must have a static IP*). Assuming that the OP has another DHCP server on the rest of his/her network (based on the statement "plug line in to lan 1 and other pc to lan 2") issues will arise (duplicate IP’s).
There are ways to run multiple DHCP servers on a network, but pre-configuration is required to prevent address overlap.
*BEFSR41 v 1 - 3 cannot be assigned an IP address by a DHCP server, it might be possible in v4. Something like a WRT54g with 3rd party firmware on the other hand will.
--
The Wagon Queen Family Truckster; sure you think you hate it now, but wait till you drive it. |
|
flibby3655
Premium
join:2004-12-19
Lompoc, CA | reply to GeekNJ
All set, thanks. Turning off or disabling DHCP is what did the trick. |
|
GeekNJ
Premium
join:2000-09-23
Waldwick, NJ | reply to Thane_Bitter
DHCP only matters if using the WAN port.
Is the original poster all set or is something still not working? |
|
Thane_Bitter
join:2005-01-20
London, ON
·Bell Sympatico
| reply to flibby3655
Did you turn off DHCP on the BEFSR41, I am working under the assumption that something else on your network is giving out IP leases?
--
The Wagon Queen Family Truckster; sure you think you hate it now, but wait till you drive it. |
|
flibby3655
Premium
join:2004-12-19
Lompoc, CA
1 edit | reply to flibby3655
Must be really ignorant... Tried to use the router as a switch. Plugged the line in to the uplink, didn't work. Tried to plug line in to lan 1 and other pc to lan 2 didn't work. Thought I reset the router, didn't work. Help!?
Google really is your best friend! Thank you world!!!!!!
--
The beatings will continue, until morale improves. |
|
flibby3655
Premium
join:2004-12-19
Lompoc, CA
1 edit | reply to GeekNJ
said by GeekNJ : It will be a switch though and not a hub. Forgive my ignorance, what's the difference between a switch and a hub?
Never mind, I looked it up... Thanks for your help!
--
The beatings will continue, until morale improves. |
|
GeekNJ
Premium
join:2000-09-23
Waldwick, NJ | reply to flibby3655
Just don't plug anything into the WAN port. Use the LAN ports. It will be a switch though and not a hub. |
|
flibby3655
Premium
join:2004-12-19
Lompoc, CA | Sorry if this has been posted before...
Can a Linksys router (BEFSR41) be dumbed down to act like a hub? If so how?
--
The beatings will continue, until morale improves. |
|
