Bytebender
Bytebender
Premium
join:2008-02-12
Canada
1 edit | reply to rawgerz
Re: Configuring DNS on 6100F?
To bridge the 6100, (or any Westell with the red and black firmware) :
access the GUI (192.168.1.1)
admin/password or admin/admin usually
if you get a user settings screen - it's the unit wanting it's password changed
select Network icon fr top menu
select network connections fr left menu
click "Broadband Connection (DSL)"
change Protocol to "bridge" only
change Bridge Mode to "bridge" only
save - the unit will reset
re-access the GUI > Network > network connections
click on "LAN"
remove the top checkmark (to disable the DHCP server
save and exit
Now the unit is just a dumb modem - it cannot make a connection and cannot hold an IP address, so the Internet light should stay off.
If the MAC of the Westell is "bound" to your public IP - you could at this point wait the 2-4 hours til the IP unbinds - or call the tech support and have them "release your IP" before you turn on the router, takes a couple minutes - or clone the MAC of the Westell into your router. This is the fastest and easiest method, most routers have this feature and the MAC should be printed on the Westell.
In bridge mode you shouldn't have to access the modem config - unless you want to check the line stats. It can be done by temporarily configuring a pc to use a static IP, (like 192.168.1.48 ; subnet 255.255.255.0 ; gateway 192.168.1.1), and connecting it directly to the bridged 6100.
--
reboot, reset, reconfigure, then recycle. |
