AjmalHanif
| LinkSyS RV082 - Two VALNs and two WAN Ports
I have LinkSyS RV082 and I'm new user.
I wana configure RV082 having below setting. VLAN 1 traffic route thru WAN1 and VLAN2's traffic through WAN2/DMZ port. No need of interVLAN routing.
WAN 1
VLAN1
.LAN1
.LAN2
.LAN3
.LAN4
WAN 2 / DMZ
VLAN1
.LAN1
.LAN2
.LAN3
.LAN4
Please replay on ajmalhanif@hotmail.com |
|
NetFixer
Freedom is NOT Free
Premium
join:2004-06-24
Murfreesboro, TN
 ·Vonage
 ·Cingular Wireless
·AT&T CallVantage
 ·AT&T Southeast
| To my knowledge, there is no way to bind a specific VLAN to a specific WAN interface. You can only do protocol and/or IP address binding.
There is no GUI menu selection for VLAN binding, and I do not see any obvious CLI method for doing that either.
Protocol Binding
IP Address Binding
--
A well-regulated militia, being necessary to the security of a free State, the right of the people to keep and bear arms shall not be infringed.
»portscan.dcs-net.net
»nature-pics.com |
|
AjmalHanif
@wateen.net | Tanks for such quick response.
Please let me know that this IP address pending will work only in routing mode or both in routing and bridge mode? |
|
