Equipment Support > Hardware By Brand > Netopia/Cayman > ADSL Startup Attempts

ADSL Startup Attempts

If you are using PPPoE it may not be connection quality but problems establishing/maintaining PPPoE session, most likely the RADIUS server.

Need to decouple loss of sync, where modem is unable to maintain connection to DSLAM, and problems with PPPoE session.

/tom

reply to GoBG
Interesting. I just got the 3347nwg-006 today and was getting these fail attempts. I reset the modem to factor settings, updated the firmware to nta774r1. Everything is good other than that. Do you connect on first attempt, tschmidt?

Normally connects on first attempt. Router has been up since momentary power failure on Christmas. Had 5 log in attempts during that period.

Here is partial log showing router power up and first connections.

 
Message Log:
12/25/08 03:58:42 AM L5      KS: Using configured options found in flash
12/25/08 03:58:42 AM L5      KS: Customer default options found in flash - using
12/25/08 03:58:42 AM L3      BOOT: Cold start v7.5.1 ---------------------------------- 
12/25/08 03:58:42 AM L3      IP address server initialization complete 
12/25/08 03:58:42 AM L3      HB: heartbeat service initializing
12/25/08 03:58:42 AM L3      HB: heartbeat option disabled
12/25/08 03:58:42 AM L4      BR: Using saved configuration options
12/25/08 03:58:42 AM L4      BR: Netopia SOC OS version 7.5.1 (build r2)
12/25/08 03:58:42 AM L4      BR: Netopia-3000/25598734 (Netopia-3000, rev 1), PID 1217
12/25/08 03:58:42 AM L4      BR: last install status: 
12/25/08 03:58:42 AM L4      BR: memory sizes - 4096K Flash, 16384K RAM
12/25/08 03:58:42 AM L3      BR: Starting kernel
12/25/08 03:58:42 AM L3      AAL5: initializing service
12/25/08 03:58:42 AM L4      ATM: Waiting for PHY layer to come up
12/25/08 03:58:42 AM L3      POE: Initializing PPP over Ethernet service
12/25/08 03:58:42 AM L4      POE: Binding to Ethernet (ether/vcc1)
12/25/08 03:58:42 AM L3      BRDG: Bridge not enabled for WAN.
12/25/08 03:58:42 AM L3      BRDG: Bridging from one WAN port to another is disabled
12/25/08 03:58:42 AM L3      BRDG: Initialization complete
12/25/08 03:58:42 AM L4      IP: Routing between WAN ports is disabled
12/25/08 03:58:42 AM L4      IP: IPSec client pass through is enabled
12/25/08 03:58:42 AM L4      IP: Address mapping enabled on interface PPP over Ethernet vcc1
12/25/08 03:58:42 AM L3      IP: Adding default gateway over PPP over Ethernet vcc1
12/25/08 03:58:42 AM L3      IP: Initialization complete
12/25/08 03:58:42 AM L3      IPSec: initializing service
12/25/08 03:58:42 AM L3      IPSec: Initialization complete
12/25/08 03:58:42 AM L3      PPP: PPP over Ethernet vcc1 binding to PPPoE
12/25/08 03:58:42 AM L3      PPP: PPP over Ethernet vcc1 Port listening for incoming PPP connection requests
12/25/08 03:58:42 AM L3      BRDG: (10/100BT-LAN) Port Physical Link Active
12/25/08 03:58:42 AM L3      IP: (10/100BT-LAN) Ethernet Physical Link Active
12/25/08 03:58:42 AM L3      IP: (10/100BT-LAN) IP Protocol Up
12/25/08 03:58:42 AM L3      RIP: initializing
12/25/08 03:58:42 AM L3      DHCP: Initializing Service
12/25/08 03:58:42 AM L3      DHCP: Setup Server On UDP Port 67
12/25/08 03:58:42 AM L3      DHCP: Setup Client On UDP Port 68
12/25/08 03:58:42 AM L3      DNS: initializing service
12/25/08 03:58:42 AM L4      DNS: nameserver address is 0.0.0.0
12/25/08 03:58:42 AM L3      SNMP: initializing service over UDP
12/25/08 03:58:42 AM L3      DIA: Diagnostics service initializing
12/25/08 03:58:42 AM L3      FW: initializing service
12/25/08 03:58:42 AM L3      FW: Firewall service is disabled
12/25/08 03:58:42 AM L3      SSL: Initializing Service
12/25/08 03:58:42 AM L3      SSL: Installed Verisign, Equifax & Thawte Root CA certificates
12/25/08 03:58:42 AM L3      SSL: Initialization Success
12/25/08 03:59:03 AM L4      RFC1483-1 up 
12/25/08 03:59:08 AM L3       Service-Name=ANY
12/25/08 03:59:08 AM L3       Host-Uniq 00000001
12/25/08 03:59:08 AM L3       AC-Name=MAN-DSL-RTR3
12/25/08 03:59:08 AM L3       AC-Cookie F109F57E8769BC834BED82FBC745E09A
12/25/08 03:59:08 AM L3      lcp: LCP Send Config-Request+
12/25/08 03:59:08 AM L3       MAGIC 0x52077cdd+
12/25/08 03:59:08 AM L3      lcp: LCP Recv Config-Req:+
12/25/08 03:59:08 AM L3       MRU(1492) (ACK) AUTHTYPE(c023) (PAP) (ACK) MAGICNUMBER
12/25/08 03:59:08 AM L3      (9af292df) (ACK)
12/25/08 03:59:08 AM L3      lcp: returning Configure-Ack
12/25/08 03:59:08 AM L3      pap: received Authenticate-Ack, id 1
12/25/08 03:59:08 AM L3      pap: Remote message: 
12/25/08 03:59:08 AM L3      ipcp: IPCP Config-Request+
12/25/08 03:59:08 AM L3       ADDR(0x0) DNS(0x0) DNS2(0x0) WINS(0x0) WINS2(0x0)
12/25/08 03:59:08 AM L3      ipcp: IPCP Recv Config-Req:+
12/25/08 03:59:08 AM L3       ADDR(10.20.12.1) (ACK)
12/25/08 03:59:08 AM L3      ipcp: returning Configure-ACK
12/25/08 03:59:08 AM L3      ppp: received frame for uninstalled protocol ()
12/25/08 03:59:08 AM L3      ipcp: IPCP Config-Request+
12/25/08 03:59:08 AM L3       ADDR(0x0) DNS(0x0) DNS2(0x0)
12/25/08 03:59:08 AM L3      ipcp: IPCP Config-Request+
12/25/08 03:59:08 AM L3       ADDR(0x4610ce7c) DNS(0x97cb0054) DNS2(0x97cb0055)
12/25/08 03:59:08 AM L3      ipcp: negotiated remote IP address 10.20.12.1
12/25/08 03:59:08 AM L3      ipcp: negotiated IP address 70.16.206.124
12/25/08 03:59:08 AM L3      ipcp: negotiated TCP hdr commpression off
12/25/08 03:59:48 AM L3      NTP: Update system date & time 
12/25/08 07:22:44 PM L4      HTTP: "admin" completed login from 192.168.2.13
12/25/08 07:27:55 PM L4      HTTP: "admin" host 192.168.2.13 logging out (timing out)
 
 

reply to GoBG
I see... it doesn't go over 3 attempts though. my last reboot it connected on the 2 try.

reply to tschmidt
tschmidt, what does the "heartbeat" option do?

reply to GoBG
I just got this in my log this morning.

IKE: no matching ph1 tunnel: sg 116.232.169.77
 

reply to GoBG

TS: "root" logging in from host 190.68.209.16
 TS: "root" failed to authenticate