toro
join:2006-01-27
Scarborough, ON
 ·TekSavvy Solutions..
1 edit | reply to rmshakil
Re: [Unlock] TUTORIAL: VONAGE WRTP54G/RTP300 WITH 5.01.04
From my experience (I've seen at leat 3-4 doing the same), that router not bricked. The firmware loads properly if the wireless light goes on.
The voice part however may have gone bad. It may work with a better power adapter (a switched power adapter with regulated voltage).
If another power adapter doesn't work, you can desolder the part labeled Q5 (the voltage regulator for the Legerity chip - see the picture) and it should become stable but will work only as a wireless router (kind of an "unorthodox" solution, but I applied it successfully to 3 or 4 routers so far) |
|
rmshakil
join:2007-01-25
Edmonton, AB
| ok I did try a 2 ampare adapter and found the samw trouble and than I removed Q5 and now it is getting on. Here my question is is there any way to trace the fault or repair the VOIP section?? Can I try upgrading the firmware and see how it behave or this mean the VOIP is dead? |
|
toro
join:2006-01-27
Scarborough, ON | I have no idea. If I knew I would have fixed mine 
I don't think another firmware would be of any help. |
|
