ferndock2
join:2007-08-01
Columbia, MD
| reply to toro
Re: [Unlock] TUTORIAL: VONAGE WRTP54G/RTP300 WITH 5.01.04
Power light is on steadily. The only times it flashes are when I power down/up or hit reset. After a power up and with the WAN (Internet) port attached to my router, the RTP300's LAN port will turn on and off at a slow rate that infrequently allows me to display the Linksys login screen. I found that by using Admin/Admin to login it says I'm not allowed at that level. Using admin/admin or user/user have not been successful because the LAN port connection doesn't stay up long enough to see a next screen. The LAN port rarely shows a connection greater than 2 seconds. How can I get this unit to give me a steady LAN connection? |
|
toro
join:2006-01-27
Scarborough, ON
 ·TekSavvy Solutions..
| I've been dealing with dozens of these routers before but I've seen only one with that issue. In that case it was a WRTP54G where the LAN ports were shot but the VoIP and wireless are working fine.
Unfortunately it's a hardware issue and I have no idea how to fix it. |
|
ferndock2
join:2007-08-01
Columbia, MD | Toro, thanks for your input. Anybody else have suggestions? |
|
mazilo
From Mazilo
Premium
join:2002-05-30
Lilburn, GA
| said by ferndock2  :Toro, thanks for your input. Anybody else have suggestions? Perhaps, you should consider waiting for this NAizer for CYT utility. |
|
ferndock2
join:2007-08-01
Columbia, MD
| Mazilo, I can't use CYT because I can't establish a connection to the RTP300 through its LAN (Ethernet, yellow) ports. Those ports give highly intermittent, very short-term connections. The only data port on the unit that seems to work correctly is the WAN (Ethernet, blue) connection. Either I coax the LAN ports into working or find a way to log into the WAN port to program it. |
|
