RedMatrix
Premium
join:2008-08-03
Mission, TX
| reply to Doctor Olds
Re: Need Admin Pass for SpeedStream 4100 (a) modem
Hey Doc, thanks for the reply.
I was able to get in somehow. Here's what I did:
I hit the reset button the the back of the modem for 10 seconds. All the LEDs were lit during reset.
Then after the modem did it's thing, I "rebooted" the modem through it's control panel.
Then, when it came back up, the password worked, and I was able to get in.
... now, I don't know what to do to set up my ISP's information. (username@att.net | password) :-/ |
|
Doctor Olds
I Need A Remedy For What's Ailing Me.
Premium,VIP
join:2001-04-19
1970 442 W30
clubs:
| said by RedMatrix  :... now, I don't know what to do to set up my ISP's information. (username@att.net | password) :-/ You would need to ask in your ISP Forum for the setting and correct VPI/VCI information (usually 0/35).
»/forum/ilec,sw···b+uverse
You would likely have to either modify the existing WAN VC settings or created a new WAN VC (Virtual Circuit with the correct settings). Once you create a New VC, you would want to check mark the box next to it. Under the setup box, it will read. "Checked interface is the default WAN interface."
--
What’s the point of owning a supercar if you can’t scare yourself stupid from time to time? |
|
