krirish
join:2009-05-15
Lakeville, IN | reply to muiredised
Re: 1701HG & Embarq
Ok so my question then is what do I need to do to get it to connect to the configuration server |
|
muiredised
ESSE QUAM VIDERI
join:2007-06-11
Tacoma, WA
1 edit | reply to krirish
Connecting to the configuration server is not going to affect your internet connection. The configuration server is part of 2wire's CMS system that collects CPE data, allows remote upgrades and access by 2wire technicians, and a whole bunch of other things. The router periodically checks in with these servers so even if the connection fails when you run the setup wizard it should continue to phone home until it gets through.
Edit: The missing options you mentioned may require a connection to the configuration server before they appear and/or work correctly however.
--
Assiduus usus uni rei deditus et ingenium et artem saepe vincit |
|
krirish
join:2009-05-15
Lakeville, IN | reply to ColonelPanic
I am still not able to connect to the configuration server |
|
ColonelPanic
join:2007-03-06
Beverly Hills, CA
| reply to krirish
You most likely still have the AT&T dynamic keycode in the gateway(522P-22P4-6262-22AT-F2NV). If embarq did not provide you with a setup code go to the broadband advanced settings and enter your providers information
•Connection type (PPPoE/PPPoA/Direct IP)
•ATM Path (VPI/VCI)
•IP settings (If applicable)
|
|
krirish
join:2009-05-15
Lakeville, IN | reply to muiredised
A key code is automatically put in when I go in there |
|
muiredised
ESSE QUAM VIDERI
join:2007-06-11
Tacoma, WA | reply to krirish
Sounds as if you have the wrong keycode. What keycode are you using?
--
Assiduus usus uni rei deditus et ingenium et artem saepe vincit |
|
krirish
join:2009-05-15
Lakeville, IN
| OK I had to restart my router when I did that and go into the system summary I am now missing options at the top and also when I try to do system setup and gets to the connection server connection search part it says unable to connect. Does anybody have any ideas? |
|
