 d_lBarsoomPremium,MVM
join:2002-12-08
Reno, NV
kudos:7 | reply to john909228
Re: [DSL] Need Help with .bat to restart my speedstream 4100 att The two main requirements to get access to the CLI are a hard reset or a GUI reset (not a restart) of the modem without passing any ATM traffic afterwards AND a direct connection to the modem.
What do you intend for the modem restart to accomplish? There might be a different way to do what you want. |
|
1 edit | Sorry for taking so long to reply, and thank you for your reply, I have been away. I am wanting to get a new Public IP address and I know that by restarting the modem, either by powering the unit down or by using the GUI interface and pressing the Disconnect and then the Restart Button a new Public IP address is assigned. I am open to other ways of accomplishing this, I just need it to be in a .bat file, so any suggestions are welcome.
Thank you once again for you time and any further help or suggestions |
|
 levI think there is a target on my backPremium,Ex-mod 2002-08
join:2001-05-30
Chicago, IL
kudos:2
 ·AT&T Midwest
| I'd probably dig up my old X-10 computer interface and a X-10 appliance control module, and just have the computer turn the modem off, wait a couple of minutes, then turn the modem back on, to make sure I didn't get the same IP address.
I have to ask... WHY are you looking to be able to change the modem's IP address so often that you'd want to set up an automated task to do so? |
|
