| reply to stevech0
Re: Belkin F5D8233 as an AP with Local only? Ok, I get that...but what I am trying to do is not have any wires.... is this even possible? I think what I'm trying to do is bridge, or extend my network. But was told I need to make it an access point to do so.
Where i get my signal and have my wireless router is impossible to run wire from there. |
|
|
|
|
Then what you want is a "repeater". Called Wireless Distribution System (WDS). Also marketed as WiFi range extenders.
Lots written about WDS here. The key points are:
1. The w-router must support WDS. Many/most don't.
2. The device (w-router) configured as a WDS repeater must be compatible with the WDS-capable w-router. Often, this means the two must be of like kind and vintage/make/model, since WDS is not part of the IEEE 802.11 standard upon which WiFi is based.
Before resorting to WDS, tell us about your laptop/PC in the weak signal area. Maybe we can improve that signal with some simple changes.
|
|
| Hmmm, interesting. I was hoping that there was some way to do this with the routers that I have. Would it work with the micro version of the wrt54g, along with another newer one of a same model, but different version?(i know they sell the wrt54g's at walmart, but they have no external antennas)
Thanks! |
|
|
First, you may not need WDS/repeater. Perhaps we can help you correct the weak signal problem by improving the laptop/PC in the weak signal area. This is best/easiest.
DD-WRT (3rd party firmware) - Don't use it unless you MUST. It's a PITA for the non-geek.
what w-router do you have now and is it WDS-capable without DD-WRT? This is best.
|
|
| The laptop is an acer....2e68c49b20.
I'm running a wireless signal from my Belkin F5D8233, I also have a WRT54G v5 that I don't have connected, but was hoping to use to extend the signal.
I am running an HP Pavillion laptop with a great signal, but beside me I have an HP Compaq SFF with a wireless card that sometimes gets a signal...not usually. |
|
| Is the issue that the Acer shows a too-weak signal? Weak means one bar or 30% or less.
If so, let's try to improve that, before leaping into WDS. |
|
| The acer has less than one bar..... 'very low signal' |
|
