rsaturns
join:2004-12-06
Portland, OR
1 edit | reply to Necrofuzzy
Re: simple point to point 1841 to 1841 through a T1
Basically you need to take the following steps.
Setup the serial interface on each 1841. If this is a true private point to point you can use whatever IP address you want highly recommend a /30 as to save address space.
Once you can ping across the T1 you’ll need to make sure that the network on the Corp side of the link is aware of the network on the far side aka a route either statically assigned or using some sort of dynamic routing protocol.
Next setup your Fast Ethernet interface on the remote site with the network subnet of your choosing make sure again from Corp you can reach that side of the far router.
Setup an IP helper *address* on that fast Ethernet interface and point it to your DHCP server back at Corp.
Make sure Corp has a scope for this remote network.
That’s the process in a nutshell with a lot of detail omitted.
Edited to say ip helper address not interface.
--
»vinfotech.blogspot.com |
|
Necrofuzzy
join:2009-06-30 | What is an ip helper interface? Is it something we can do with sdm, (sad) thats what were trying to set it up with. Were noobs .  |
|
rsaturns
join:2004-12-06
Portland, OR | Edited above post should be address not interface.
--
»vinfotech.blogspot.com |
|
