| reply to nfx
Re: Issues with Cisco 871 tunnel with Pix515e When you do a "permit ip" you are permitting everything over the protocol stack which would include TCP, UDP and ICMP.
I did fix the issue by removing "ip nat inside" on "int vlan1" and removing "ip nat outside" from "int f4". Since vlan 1 was not coming up I added my Loop Back IP into the tunnel ACL and then I was able to ping and telnet to ports on both sides of the crypto tunnel. |
|
 nfxThe WirePremium
join:2001-05-21
Vancouver, BC
kudos:1 | You're right. I had to go back and review CCNA material to realize this. Thanks.
--
nfx |
|
