Broadband Tech > Wireless Networking > DSL Connectivity and D-Link 655

reply to CylonRed

Re: DSL Connectivity and D-Link 655

Does the Westell W327 modem have an exact model# on the sticker?

This is about as exact as its going to get

Westell D90-327W15-06
Rev: C

Thanks, but how does this help?

reply to merlin353
You should be able to disable Wireless on the 327w, then configure it as an unrouted bridge. Then use your router to handle the routing and WiFi.

If your ISP uses PPPoE, then you will need to setup PPPoE on the router. If your ISP does not use PPPoE, then before reconfiguring the 327w, click on the "disconnect" link. And as soon as it is disconnected, unplug from the phone line. Hopefully that will release any DHCP lease so that the new router can get an IP address without having to clone the 327w MAC address. With some ISPs, you might have to phone to have them release the link between your 327w MAC address and your service.
--
AT&T dsl; Speedstream 5100b modem; openSuSE 11.0; firefox 3.0.11

reply to merlin353

nwrickert, mountaineer1

Thanks for your help, I'll follow-up with Verizon and such.

Regards
Bob

Here's the tutorial,"Changing your VersaLink 327W gateway to Bridge Mode",on Verizon's website. Hope this helps.
--
Got a Clark,Crown,Drexel forklift and need technical advice? Ask me about it.

Thank you Mountaineer

Okay, this is the last of the dumb questions (I hope).

I read the Verizon instructions in its entirety. At the end of the process its tells me I'm in Bridge mode and then it tells how to turn Wireless on and then says to follow the third-party instructions to attach the new router to the verizon network.

I was my understanding that once I put it in Bridge mode the connection between the modem and DIR655 would be WAN cable.

My questions is, Once its in Bridge mode, why would I want to turn wireless on?

Thanks
Bob

Only if you want to. It says to skip to 26,if you don't what the wireless radio on.
--
Got a Clark,Crown,Drexel forklift and need technical advice? Ask me about it.