nosx
join:2004-12-27
00000
kudos:4
2 edits | reply to metalmachine
Re: Assistance with 2 Cisco 2600 Routers via T1 PPPI believe you need a different "t1 crossover cable". The pinout is different i believe.
When going back to back without a DXC in the middle, i usually configure both of them as clock source line.
Be sure to set linecode and framing to B8ZS and ESF, and use timeslots 1-24 speed 64
Full T1 (1536kbps) clear-channel/subrate config:
interface Serial0/0
no shutdown
ip address 77.66.55.44 255.255.255.0
service-module t1 clock source line
service-module t1 timeslots 1-24 speed 64
exit
|
