5260 - lost IP - dslreports.com

Author	All Replies
andyr join:2009-07-18 Australia 2 edits	5260 - lost IP Hi all, I have an (old!) Efficient 5260 that is working fine in bridge mode however it does not respond to telnets or pings to 10.0.0.1 --- is there any way of resetting the modem (other than a power off which doesn't help) so that it remembers it's IP? I also have one that all 4 lights come up red when powered up (and stays that way) - is this one only good for a wheel chock?? Both modems (and a third that is working 100% as a 5660 router) are 5260's with part number 060-5660-004. Thanks Andrew
andyr join:2009-07-18 Australia 2 edits	to forum · permalink · · 2009-07-18 02:31:42 ·
Doctor Olds I Need A Remedy For What's Ailing Me. Premium,VIP join:2001-04-19 1970 442 W30 clubs:	You have to setup your PC with a Static IP in order to access the unit when in Bridge Mode as DHCP is off in that mode. »The Unofficial SpeedStream 5260 ---> 5660 FAQ »How do I telnet into my modem? -- What’s the point of owning a supercar if you can’t scare yourself stupid from time to time?
	to forum · permalink · · 2009-07-18 08:03:45 ·
andyr join:2009-07-18 Australia	Yup - fully realise that - PC had a static of 10.0.0.199 which could ping the 10.0.0.1 address of the 5260-now-5660. The 5260 that still is a 5260 doesn't give any ping responses and I can't telnet into it, indicative that it has lost its 10.0.0.1 IP - still works as a bridge though.... thats the one I was asking about. The third one I think is wheel chock material..... (all constant red lights).
andyr join:2009-07-18 Australia	to forum · permalink · · 2009-07-18 08:42:41 ·
Doctor Olds I Need A Remedy For What's Ailing Me. Premium,VIP join:2001-04-19 1970 442 W30 clubs:	The only thing I can think of that would cause lost access is enabling the Bridge Filter in Telnet. »The Unofficial SpeedStream 5260 ---> 5660 FAQ »What the heck is a bridge filter? What do I do with it? You can reset the unit, but you have to add a serial port to do so as the 5260 is missing the 5660's serial port. The FAQ below explains that process. »The Unofficial SpeedStream 5260 ---> 5660 FAQ »HELP! I Can't upgrade my 5260 after flashing Firmware 2.2.x on it! What do I do? As to the unit with all Red LEDs, that sounds like it suffered an overheat or a power spike. Are you using the correct power supply? -- What’s the point of owning a supercar if you can’t scare yourself stupid from time to time?
	to forum · permalink · · 2009-07-18 09:50:20 ·


Saturday, 28-Nov 06:31:18	Terms of Use \| Privacy Policy \| Hosting by www.nac.net - DSL,Hosting & Co-lo \| feedback \| contact over 10 years online! © 1999-2009 dslreports.com. republican-creole page compression OFF