http://www.dslreports.com/forum/r22727956 en Wed, 10 Feb 2010 03:36:50 EDT Wed, 10 Feb 2010 03:36:50 EDT http://www.dslreports.com/forum/remark,22728493 Doctor Olds : The only thing I can think of that would cause lost access is enabling the Bridge Filter in Telnet.

»The Unofficial SpeedStream 5260 ---> 5660 FAQ »What the heck is a bridge filter? What do I do with it?

You can reset the unit, but you have to add a serial port to do so as the 5260 is missing the 5660's serial port. The FAQ below explains that process.

»The Unofficial SpeedStream 5260 ---> 5660 FAQ »HELP! I Can't upgrade my 5260 after flashing Firmware 2.2.x on it! What do I do?

As to the unit with all Red LEDs, that sounds like it suffered an overheat or a power spike. Are you using the correct power supply?

[att=1]
--
What’s the point of owning a supercar if you can’t scare yourself stupid from time to time?

]]> http://www.dslreports.com/forum/remark,22728493 Sat, 18 Jul 2009 09:50:20 EDT http://www.dslreports.com/forum/remark,22728327 andyr : Yup - fully realise that - PC had a static of 10.0.0.199 which could ping the 10.0.0.1 address of the 5260-now-5660.

The 5260 that still is a 5260 doesn't give any ping responses and I can't telnet into it, indicative that it has lost its 10.0.0.1 IP - still works as a bridge though.... thats the one I was asking about.

The third one I think is wheel chock material..... (all constant red lights).]]> http://www.dslreports.com/forum/remark,22728327 Sat, 18 Jul 2009 08:42:41 EDT http://www.dslreports.com/forum/remark,22728259 Doctor Olds : You have to setup your PC with a Static IP in order to access the unit when in Bridge Mode as DHCP is off in that mode.

»The Unofficial SpeedStream 5260 ---> 5660 FAQ »How do I telnet into my modem?
--
What’s the point of owning a supercar if you can’t scare yourself stupid from time to time?]]> http://www.dslreports.com/forum/remark,22728259 Sat, 18 Jul 2009 08:03:45 EDT http://www.dslreports.com/forum/remark,22727956 andyr : Hi all,

I have an (old!) Efficient 5260 that is working fine in bridge mode however it does not respond to telnets or pings to 10.0.0.1 --- is there any way of resetting the modem (other than a power off which doesn't help) so that it remembers it's IP?

I also have one that all 4 lights come up red when powered up (and stays that way) - is this one only good for a wheel chock??

Both modems (and a third that is working 100% as a 5660 router) are 5260's with part number 060-5660-004.

Thanks

Andrew]]> http://www.dslreports.com/forum/remark,22727956 Sat, 18 Jul 2009 02:31:42 EDT