http://www.dslreports.com/forum/Rising-latency-and-disconnects-23198745 en Thu, 09 Feb 2012 19:47:27 EDT Thu, 09 Feb 2012 19:47:27 EDT http://www.dslreports.com/forum/Re-Rising-latency-and-disconnects-23201083
IM MrFixitCT with the phone number and he can look into what's going on from AT&Ts end.]]> http://www.dslreports.com/forum/Re-Rising-latency-and-disconnects-23201083 Sat, 17 Oct 2009 22:40:03 EDT http://www.dslreports.com/forum/Re-Rising-latency-and-disconnects-23200982 http://www.dslreports.com/forum/Re-Rising-latency-and-disconnects-23200982 Sat, 17 Oct 2009 22:16:19 EDT http://www.dslreports.com/forum/Re-Rising-latency-and-disconnects-23199304 Downstream Rate Cap: 3008 kbps
Downstream Atten. at 300kHz: 36.0 dB
Uncancelled Echo: -20.1 dB Ok
VCXO Frequency Offset: -57.5 ppm Ok
Final Rx Gain: 18.4 dB Ok
Impulse Noise Comp. Tones: 0 Ok
Excessive Impulse Noise: 0 Ok
Impulse noise protection: 2.49
Delay of latency path: 16.00 ms

How do I find the exact figures you need? Kinda new to this.

DSL Line (Wire Pair): Line 1 (inner pair)
Protocol: G.DMT Annex A
Downstream Rate: 3008 kbps
Upstream Rate: 512 kbps
Channel: Interleaved
Current Noise Margin: 30.0 dB (Downstream), 23.0 dB (Upstream)
Current Attenuation: 41.4 dB (Downstream), 25.5 dB (Upstream)
Current Output Power: 18.9 dBm (Downstream), 12.1 dBm (Upstream)
DSLAM Vendor Information: Country: {0xB5} Vendor: {BDCM} Specific: {0x4D54}
PVC Info: 0/35


Is this it?]]> http://www.dslreports.com/forum/Re-Rising-latency-and-disconnects-23199304 Sat, 17 Oct 2009 14:29:14 EDT http://www.dslreports.com/forum/Re-Rising-latency-and-disconnects-23199173
It's apparent that you have Pro service [the 512 kbps upstream figure is the tip-off], but you were only connecting at 2240 kbps downstream instead of the usual 3008 kbps.

The reason you weren't connecting at 3008 is that your downstream noise margin was only 10dB at 2240 kbps. At least some of the higher latency could be the result of your line being placed in interleave mode [I believe this is set automatically if a connection drops frequently] at AT&Ts end. Interleave mode has error correction to compensate for poor line quality, but results in increased latency.

If there are significant differences between line stats at different outlets in your house, you may want to drag a long extension cord and your gateway outside and connect them directly to the test jack outside. »AT&T Southeast Forum FAQ »How to check modem stats, synch rates & speeds from test jack at the NID.

If the stats outside are considerably better than inside, you can either install a 'home run' or choose the inside jack that gives you the best stats.

When, after any and all relocating/rewiring, you're satisfied you connection is OK, post in the AT&T Direct forum for help from an AT&T tech [or see if MrFixitCT can look at things for you].
]]> http://www.dslreports.com/forum/Re-Rising-latency-and-disconnects-23199173 Sat, 17 Oct 2009 13:50:52 EDT http://www.dslreports.com/forum/Re-Rising-latency-and-disconnects-23199077 http://www.dslreports.com/forum/Re-Rising-latency-and-disconnects-23199077 Sat, 17 Oct 2009 13:22:20 EDT http://www.dslreports.com/forum/Re-Rising-latency-and-disconnects-23198952
All my phone filters and set right and haven't changed in the past months. Could one of them just go haywire randomly?]]> http://www.dslreports.com/forum/Re-Rising-latency-and-disconnects-23198952 Sat, 17 Oct 2009 12:44:57 EDT http://www.dslreports.com/forum/Re-Rising-latency-and-disconnects-23198910 DSL Line (Wire Pair): Line 1 (inner pair)
Protocol: G.DMT Annex A
Downstream Rate: 2240 kbps
Upstream Rate: 512 kbps
Channel: Interleaved
Current Noise Margin: 10.0 dB (Downstream), 15.0 dB (Upstream)
Current Attenuation: 40.4 dB (Downstream), 31.5 dB (Upstream)
Current Output Power: 18.2 dBm (Downstream), -2.6 dBm (Upstream)
DSLAM Vendor Information: Country: {0xB5} Vendor: {BDCM} Specific: {0x4D54}
PVC Info: 0/35
Internet Connection Details
Connection Type: PPPoE
Username: stcyrn@sbcglobal.net
Internet Address: 76.237.97.58
Subnet Mask: 255.255.255.255
Default Gateway: 204.60.4.186
Primary Domain Name Server: 68.94.156.1
Secondary Domain Name Server: 68.94.157.1
Domain:
Maximum Transmission Unit (MTU): 1492
Gateway Ping: Successful
DNS Communication: Successful
Configuration Server Post: Successful]]> http://www.dslreports.com/forum/Re-Rising-latency-and-disconnects-23198910 Sat, 17 Oct 2009 12:26:41 EDT http://www.dslreports.com/forum/Re-Rising-latency-and-disconnects-23198867 192.168.1.254/xslt?PAGE=B02&THIS···PAGE=B02 should show you your line stats.

We need the 'DSL Connection Details'.]]> http://www.dslreports.com/forum/Re-Rising-latency-and-disconnects-23198867 Sat, 17 Oct 2009 12:09:09 EDT http://www.dslreports.com/forum/Rising-latency-and-disconnects-23198745
Seems a couple of months ago I could connect to a Dallas server and get a ping of 60 at worst. Now I connect to New York servers at a constant 130. Last week it was 95.

I've disconnected all my phones and still have the problem.

Pinging yahoo is a constant 130 ms. Tried resetting router and still the same problems.

Everyone morning before the family gets up I'll be on the internet and randomly be disconnected at least once and hour.

Could both problems be related?

I don't know how to interpret the numbers in data errors section of my 2701hg-b 2 wire.

Any help would be appreciated.]]> http://www.dslreports.com/forum/Rising-latency-and-disconnects-23198745 Sat, 17 Oct 2009 11:31:44 EDT