hattster
@shawcable.net
| Initial Configuration of ASA5505's
Hey,
I was hoping somebody here can help me with an easy issue I am facing. I am directly connecting two ASA 5505 devices on their outside ports and plan on creating a VPN tunnel. However I am running into problems even before I configure the VPN.
I ran the initial factory config then configured the IP addresses as follows:
ASA1 (outside): 10.128.84.101
ASA1 (inside): 10.179.5.254
comp1 (inside) : 10.179.5.5
ASA2 (outside): 10.128.86.9
ASA2 (Inside): 10.179.1.254
comp2 (inside) : 10.179.1.5
At the moment I have them both connected on eth0/0 which is the outside interface configured on VLAN 2. Before I configre the VPN tunnel I want to be able to ping between the two computers on the opposite inside interfaces, however I can't seem to get this to happen. I tried to configure static routes but nothing seems to work.
I pasted my config below, I would appreciate any help.
ASA Version 7.2(4)
!
hostname ciscoasa
enable password 2KFQnbNIdI.2KYOU encrypted
passwd 2KFQnbNIdI.2KYOU encrypted
names
!
interface Vlan1
nameif inside
security-level 100
ip address 10.179.5.254 255.255.255.0
!
interface Vlan2
nameif outside
security-level 0
ip address 10.128.84.101 255.255.255.0
!
interface Ethernet0/0
switchport access vlan 2
!
interface Ethernet0/1
!
interface Ethernet0/2
!
interface Ethernet0/3
!
interface Ethernet0/4
!
interface Ethernet0/5
!
interface Ethernet0/6
!
interface Ethernet0/7
!
ftp mode passive
pager lines 24
logging asdm informational
mtu inside 1500
mtu outside 1500
icmp unreachable rate-limit 1 burst-size 1
icmp permit any inside
icmp permit any outside
no asdm history enable
arp timeout 14400
global (outside) 1 interface
nat (inside) 1 10.179.5.0 255.255.255.0
nat (inside) 1 0.0.0.0 0.0.0.0
nat (outside) 1 0.0.0.0 0.0.0.0
route inside 10.179.1.0 255.255.255.0 10.179.5.254 1
route outside 0.0.0.0 0.0.0.0 10.128.86.9 1
timeout xlate 3:00:00
timeout conn 1:00:00 half-closed 0:10:00 udp 0:02:00 icmp 0:00:02
timeout sunrpc 0:10:00 h323 0:05:00 h225 1:00:00 mgcp 0:05:00 mgcp-pat 0:05:00
timeout sip 0:30:00 sip_media 0:02:00 sip-invite 0:03:00 sip-disconnect 0:02:00
timeout sip-provisional-media 0:02:00 uauth 0:05:00 absolute
http server enable
no snmp-server location
no snmp-server contact
snmp-server enable traps snmp authentication linkup linkdown coldstart
telnet timeout 5
ssh timeout 5
console timeout 0
!
class-map inspection_default
match default-inspection-traffic
!
!
policy-map type inspect dns preset_dns_map
parameters
message-length maximum 512
policy-map global_policy
class inspection_default
inspect dns preset_dns_map
inspect ftp
inspect h323 h225
inspect h323 ras
inspect rsh
inspect rtsp
inspect esmtp
inspect sqlnet
inspect skinny
inspect sunrpc
inspect xdmcp
inspect sip
inspect netbios
inspect tftp
!
service-policy global_policy global
prompt hostname context
Cryptochecksum:dc413c0ca1b179de74d953e9a32146a3
: end |
|
elnino
join:2006-08-27
Akron, OH | You'll need to change the IP on one of the firewalls or add a router in between the ASAs. You can't get from 10.128.84.101 to 10.128.86.9 without some router in between since they're on different subnets |
|
