how-to block ads
|
|
Uniqs:
2845 |
Share Topic
 |
 |
|
| [Cable] WebSTAR EPC2100R2 I just got one of these installed this morning. My surfboard ended up dying on me after afew good years of service. When he installed it, the lights on the front which were on (solid) were cable & power with data send & receive flashing as if should be but now the PC light is flashing, I've read the manual but I'm not sure what it means, data been send from my pc to modem? doesn't mean anyones using the connection does it? wireless is disabled on my system, its a stand alone wired up. anyway, I've got 10MB virgin media broadband could anyone please take a look at the following report from, »192.168.100.1/
Name
WebSTAR EPC2100R2
Hardware Version
2.1
Software Version
v2.0.2r1256-070601
Receive Power Level
6.7 dBmV
Transmit Power Level
48.0 dBmV
Cable Modem Status
Operational
Downstream Status
Operational
Channel ID
3
Downstream Frequency
339000000 Hz
Modulation
256QAM
Bit Rate
10240000 bits/sec
Power Level
6.7 dBmV
Signal to Noise Ratio
41.5 dB
Upstream Status
Operational
Channel ID
4
Upstream Frequency
34000000 Hz
Modulation
16QAM
Symbol Rate
512000 bits/sec
Power Level
48.0 dBmV
Time Not Established Critical (3) DHCP WARNING - Non-critical field invalid in response.
Time Not Established Critical (3) Received Response to Broadcast Maintenance Request, But no Un...
Time Not Established Critical (3) No Ranging Response received - T3 time-out
Time Not Established Critical (3) DHCP WARNING - Non-critical field invalid in response.
Time Not Established Critical (3) No Ranging Response received - T3 time-out
Time Not Established Critical (3) DHCP WARNING - Non-critical field invalid in response.
Time Not Established Critical (3) No Ranging Response received - T3 time-out
Time Not Established Critical (3) SYNC Timing Synchronization failure - Failed to acquire FEC f...
Time Not Established Critical (3) DHCP WARNING - Non-critical field invalid in response.
Time Not Established Critical (3) No Ranging Response received - T3 time-out
Time Not Established Critical (3) Resetting the cable modem due to console command
Time Not Established Critical (3) SYNC Timing Synchronization failure - Failed to acquire QAM/Q...
Time Not Established Critical (3) Resetting the cable modem due to console command | |
| just to add, the pc light on the modem also flashes when pc is turnt off. is that the isp communicating with the modem? | |
|
