| reply to TomS_
Re: [CCNA] switchport mode access : Command Question : Why use i This was taken from figure 9.10
If you have Todd L CCNA book.
Page 576.
What does this configuration NOT use
switchport access mode when configuring VLANS.?????
2960# Config t
2960(config)#int f0/1
2960(config-if)#switchport mode trunk
2960(config-if)#int f0/2
2960(config-if)#switchport access vlan 1
2960(config-if)#int f0/3
2960(config-if)#switchport access vlan 1
2960(config-if)#int f0/4
2960(config-if)#switchport access vlan 3
2960(config-if)#int f0/5
2960(config-if)#switchport access vlan 3
2960(config-if)#int f0/6
2960(config-if)#switchport access vlan 2 |
