 backfeedis giving feedback
join:2002-12-16
Peru, IN
 ·Comcast
| reply to Noah Vail
Re: Dang I am not sure..I do remember during boot up that there was a link that rolled by about xfree86.
I then assumed that that was the kernel.
The CNC runs a proprietary software on tob of this. The Networking setup menus are pretty slim and the documentation from the manufacture is Less than Poor.
I will change it to map to a permanent share on a client that I will be installing next week that will be a full time workstation that I will be using for some other tasks. Should work out OK.
I thank you for the interest and help Noah!!!
--
There are 10 types of people. Those who can read Binary and those who cannot. |
