 DarkLogixPremium
join:2008-10-23
Baytown, TX
kudos:3
2 edits | [Cooling] H70 soon to be installed so I've recived the 2 120mm fans I orderd
thermaltake AF0026 to put on my H70
to compair the differance is air pressure that the AF0026's give off can move an empty soda can, the fans the came with the H70 can't
theres obviously an airflow drop when bolted to the radiator but the af0026 can still move the soda can |
|
|
|
| I still yet to replace my H70 (and case) fans.
How's the noise level of the Thermaltake as compared to the Corsair OEM? |
|
DarkLogixPremium
join:2008-10-23
Baytown, TX
kudos:3 | I haven't installed it yet but compairing the sound when they were sitting on my desk the thermaltake are louder but they do come with a small controller so you could turn them down a little (I won't)
its not very loud but I'd say theres more of a humming sound and you hear almost nothing with the corsair
I've now replaced my old thermaltake icage fans with the same model (3 120's on the front of the case) and I can hear them but it kinda blends in with my router sound so I don't mind
I think I'll install the H70 this weekend (just holding off due to all the trouble I'll have to go through to remove the mobo to install the H70) |
|
DarkLogixPremium
join:2008-10-23
Baytown, TX
kudos:3 | well the h70 is in and it cooling much better than the stock cooler
now to wait on the thermal compount to cure and see the temps then
at full load running ycruncher it didn't go over 50c where as the stock cooler was getting much hotter and thats before the arctic silver 5 has had a chance to set in |
|
BarneyBadAssBadasses Fight For FreedomPremium
join:2004-05-07
00001 | reply to DarkLogix
DarkLogix,
Hopefully your AS5 has cured, what kinds of temps are you seeing these days?
Thanks
--
---Barney |
|
DarkLogixPremium
join:2008-10-23
Baytown, TX
kudos:3 | idle has been about 34-35c full load (ycruncher doing 4billion places all in ram) hits it to about the low 50's
I'll run it again to verify
though I had to replace the on eI had due to the pump acting up and not cooling but the replacement has been great
also as I noticed one of the other temps that the hardware monitor was showing had risen I've added a HyperX ram cooler because the ram doesn't have the air coming off the cpu anymore |
|
BarneyBadAssBadasses Fight For FreedomPremium
join:2004-05-07
00001 | reply to DarkLogix
and this is on what kind of CPU?
I've got an i7 920 and I see the same kinds of temps using a thermalright 120UE with a panaflo 120 x 38mm fan..
--
---Barney |
|
 DKSDamn Kidney StonesPremium,ExMod 2002
join:2001-03-22
Owen Sound, ON
kudos:2
 ·Bell Sympatico
| reply to DarkLogix
said by DarkLogix:I've now replaced my old thermaltake icage fans with the same model (3 120's on the front of the case) and I can hear them but it kinda blends in with my router sound so I don't mind
If your router is making noise, then you have a serious electrical problem.
--
Need-based health care not greed-based health care. |
|
DarkLogixPremium
join:2008-10-23
Baytown, TX
kudos:3 | my router is a cisco 3745 it has some ok sized fans so ya its hearable |
|
DarkLogixPremium
join:2008-10-23
Baytown, TX
kudos:3 | reply to BarneyBadAss
said by BarneyBadAss:and this is on what kind of CPU?
I've got an i7 920 and I see the same kinds of temps using a thermalright 120UE with a panaflo 120 x 38mm fan..
i7 930
the last 4g run of ycruncher peaked at 54 but that was for les than a sec here and there and was at 48c most of the time for the 40min run of ycruncher |
|
DKSDamn Kidney StonesPremium,ExMod 2002
join:2001-03-22
Owen Sound, ON
kudos:2 Reviews:
·Bell Sympatico
| reply to DarkLogix
said by DarkLogix:my router is a cisco 3745 it has some ok sized fans so ya its hearable
That's a router and a third.
--
Need-based health care not greed-based health care. |
|
DarkLogixPremium
join:2008-10-23
Baytown, TX
kudos:3 | I need to update my picture of my network but my home network consists of the following
cisco 3745
NM-1GE
NME-16ES-1G
WS-C2960G-24TC-L
and a 1242AG ap
then of course a SMC D3 modem
and I have a Cat7 cable going from the SMC to the NM-1GE and another from the NME-16ES-1G to the WS-C2960G-24TC-L |
|
